Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

37-93 hot resister
#16

so a hi voltage winding shorted to xfrm housing?
you may be able to take it apart and fix it,output leads may be crumbling like the rest of the wiring.
phil
#17

Icon_biggrin OK, I rewired the transformer and now the resister does not get hot. The old wire was brittle and it had crack in just the right place for voltage to jump to the chassis. I was suspicious of that 134 VAC on the center tap. Now there is just .5 to 2 VAC there.

Later I will see about aligning the radio and see if I can pick up anything.

Thanks for you help Phil and everyone else.
#18

sorry i jumped out,had to take an a.s.e. L1 test-BRUTAL!!! but i passed!
good the you cleared the short,radio is working now?
aaahhh the sweet sounds of success!
good work and welcome to the addiction,now go find another one.
phil
#19

Phil

Like I said, thanks for the help. It's receiving, just needs a few tweeks. Got a Model 60 on the back burner.
#20

the 60 will be fun,be sure to read ron's 60 info,many many changes made in that one.
phil




Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM

[-]
Who's Online
There are currently 5492 online users. [Complete List]
» 1 Member(s) | 5491 Guest(s)
Avatar

>