Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Rogers 10-12 finished
#1

  I have finally finished my Rogers 10-12 console. It has been five years since I bought the radio and at that time it didn't have a power supply. I found another one with the power supply  and now I have one complete radio.. I stripped and refinished the cabinet, changed the capacitors, but it still had a problem.
   With the help of a good friend it is now working very well.
It is the holy Grail of Canadian radios so now it sits in my dining room.  BUT  I am still looking for a power supply and a clock.


Attached Files Image(s)
                   

   Living in Calgary Alberta
#2

Looks beautiful!
Icon_thumbup Icon_thumbup Icon_thumbup
#3

Really stunning radio. I even think that my wife wouldn't mind having it outside the basement Icon_smile

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
#4

The Canadian sets sure seem to have over the top cabinets! Too bad they're so expensive to ship to the states. I would like to have one or two....
#5

All I can say is wow!! They really put a lot of detail into that radio cabinet! It is a beautiful console and a keeper in anyones collection. Good luck with it and she's a keeper for sure. Icon_thumbup Icon_thumbup Icon_thumbup




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently 1938 online users. [Complete List]
» 1 Member(s) | 1937 Guest(s)
Avatar

>