Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

48-482 Performance Second Opinion
#1

OK folks I have restored a 48-482 radio and carefully aligned it. All the IF's demonstrated a sharp sweet spot during alignment so the cans should be OK. The radio works fairly well, even the FM. I am some what disapointed at the performance of the AM and SW sensitivity. Am I expecting too much? This thing has 3 IF's and I somewhat expect more because of it. I must disclose that the detector and 1st audio ( 7B6 ) does test weak on a tester. All the rest test really, really good on the tester and my benchmark 6V6 tube tests as usual. Like most in this hobby I have seen weak tubes work good and "good / tested " tubes not.

SW band is fairly quiet but works and AM picks up all local and some stations 50 miles away but the volume has to be up. Is this just what it is for this radio. Will an antenna setup of some type pluged in to the 4 pin scocket on the rear improve it? Any wire clipped to it just hurts the performance at this time. Do I need a tuned loop? Again that seems like over-kill for a 3 IF stage radio. I do realize it's a converter front end.

So what do ya think? My ears' to the ground at the best gathering of OT (original technology) radio techs I know of so somebody....throw me a bone.

Dave Casazza
Keep em glowin and goin...
#2

Dave,

I have had one of these sets in the bedroom for almost 20 years and the AM and shortwave should be hot. This the only Philco table model with inverse feedback and has a sound that no other 1948 table set has. I have the set below it, the 48-475 which sounds rather plain. The biggest problem I had found with most early post-war FM sets is the oscillator radiates terribly on FM. Philco uses a rather odd IF frequency on FM. Before the days of cable, when tuning the set to 93.3, one of our local rock stations, channel 6 TV was totally unwatchable. Cable and now digital broadcast has eliminated that problem.

I find that most of the 40's Philcos with the "low-noise" front ends with 7F8s or similar setups with XXLs or XXDs, with the extra IF stages and low impedance loops, work extremely well. Is your loop hooked correctly and is the matching transformer that couples it to the 7F8 OK? The 7W7 RF stage is not used on AM and shortwave. The loop is coupled to the 7F8 mixer section through the loop transformer inside the RF deck.

Fred
#3

Made it better
While mucking around one last time before mounting it back in the cabinet I noticed the reception got better if I touched the mica cap lead between the ant coil and the converter tube with a small screw driver so I replaced it. Wow is this front end HOT. Even SW got a shot in the arm. I'm DXing the eastern US and don't know what else (at night of course) with the 3 turn loop ant it brung to this dance. Even though the RF peaked as I adjusted the ant trimmer; still, it got better if I touched the 22pf's lead. I figure it should get worse if I touched it by throwing it out of tune.
I mis-read the schematic and replaced a 22pf with a 220pf cap. The Ant Trimmer range on BC and SW is the same as with the old 22 pf mica cap
A 27pf cap took me back to the old disapointment. The 220pf is back in service!

Now here's the question.
Did I discover a new mod?
Is there a replacement of a slowly failing ant coil in my future? This coil ohm'd out OK and looks very good. As much as I want the radio to be original I also realize that success is measured by results.

Thoughts?

Dave Casazza
Keep em glowin and goin...




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 38-2 Automatic Tuning
Hi Richard, I enjoy it to some extent. I do that type of work out in barn (modern) during the summer on nice days when I...dconant — 03:13 PM
Philco 38-2 Automatic Tuning
hello dconant , my set is the tabletop one and it also needs refinished someone put plant or something on top and the f...radiorich — 02:56 PM
Philco 38-2 Automatic Tuning
Well, you could take a look at most features of those radios, and other than some very few of them, they all are selling...morzh — 02:20 PM
SABA 400 Automatic Stereo 11
I actually got to hear the SABA play today when I took my Westinghouse AM-FM up to be worked on and also now know a pric...Jayce — 02:08 PM
Philco 38-2 Automatic Tuning
Seems more like a selling point to me. I too have have a Philco with the Cone-Centric tuning. Hopefully I will get the ...dconant — 12:17 PM
Philco 38-2 Automatic Tuning
I found out, I never use it in my 37-116 and 38-690. I made sure it works, but this was it: I always hand tune.morzh — 10:55 AM
Philco 38-2 Automatic Tuning
Does it wash your windows? Then it would be useful and worth fixing. Music and window washing.RodB — 10:00 AM
Philco 38-2 Automatic Tuning
You press the lever (crank) and you rotate the dial into the desired position. Also, while pressed, the contact that it...morzh — 09:50 AM
Philco 91 Speaker Replacement
I do not have much experience with speakers, but acetone sounds right. It does not affect paper but does dissolve about ...morzh — 09:48 AM
Philco 38-2 Automatic Tuning
Hello Dconant, In my collection I have a model 38-7T which Philco called their famous "Cone-Centric" dial me...radiorich — 08:14 AM

[-]
Who's Online
There are currently 1460 online users. [Complete List]
» 2 Member(s) | 1458 Guest(s)
AvatarAvatar

>