Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 41-280 (121)
#1

Does anyone here know all the part #'s or the specs on all the lights in this system if I need to replace them.

I was going to use radiodaze.com for the parts but don't know the lamps
#2

I think they are #44, 6.3v, 250ma, bayonet mount. Those were in my 41-280 when I got it. I tried #47 when I restored it, but at 150ma, they seemed too dim. I also tried #44 in the dial lamp with #47 in the band select lights on the side, but I didn't like the effect, so I went with #44 all around. You can buy these from Radio Shack fairly cheaply if one of those stores is nearby, and see what effect you like best.

John Honeycutt
#3

John is correct. According to the service info and Chuck's website, the lamps for the indicator and push-button are type 44 (Philco # 34-2064). The dial lamp has the same specs as the 44 but has a frosted top (Philco # 34-2210).

Sean
WØKPX




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM

[-]
Who's Online
There are currently 5088 online users. [Complete List]
» 1 Member(s) | 5087 Guest(s)
Avatar

>