Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco T 760 tube configuration
#1

Good Morning everybody. In the past days I bought a Philco Tropic marketed as model T 760, year 1942. Unfortunately, I don´t have the tube configuration for replacing them. The radio is working, but I want to have a tube stock for the future. Thanks a lot. Nallo 69
#2

Don't any of the tubes still have their type markings? Just make a list and a diagram of where they go.
If some of the tubes are "cleaned off" and you cant get a number off them, try huffing your breath around the glass portion.
Best to chill the tube in the fridge for 5-10 mins first to help create the fogging effect.
#3

Thanks for your answer Chuck. I´ll try to do what you say. By the way, at your question, any of the tubes has it´s mark, they are quite old, so the task will be hard.
#4

The model number should be 42-760T
http://www.radiomuseum.org/r/philco_42_760.html
This service info may help you:
http://www.nostalgiaair.org/PagesByModel...013549.pdf

Carl
Northern Panhandle, WV
#5

Thanks for the information Mr. Davis it was very useful.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM

[-]
Who's Online
There are currently 5692 online users. [Complete List]
» 1 Member(s) | 5691 Guest(s)
Avatar

>