Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

So! Am I a big dumby?
#1

I should have known better. Icon_rolleyes I am looking to get a 37-610T bullet radio, and bought a servive manual ahead of the radio. Upon looking closer, I see the manual is to a 37-610 not a 37-610T. Icon_redface So are these the same chassis or do I get the big DAH! award? Icon_lol

tractorforum.com *** I reserve the right to be wrong
#2

Don't worry, it is the same...that is, unless you have a Service Bulletin for a 37-610 Code 121 or 122, and end up owning a 37-610 Code 125 or 126.

The main difference is that the RF units are different. Also, if you want a table model it will be Code 122 or 126 (the rectifier tube is behind the power transformer, not mounted on top of it as in Codes 121 or 125).

--
Ron Ramirez
Ferdinand IN
#3

Thanks Ron. I thought that might be the case but wasn't sure. It only cost me a few bucks, and it is an original copy. Now I just gots to locate a radio. Icon_biggrin

tractorforum.com *** I reserve the right to be wrong




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM

[-]
Who's Online
There are currently 4799 online users. [Complete List]
» 1 Member(s) | 4798 Guest(s)
Avatar

>