Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

39-6173 Bakelite
#1

I am a complete novice here and have one Philco radio with 39-6173 on a sticker on the inside of the cabinet and AX16093 stamped on the chassis.

I'd like to know what I have. Picture below.

Thanks...and if I need to do some remedial reading, just point me to the sources.

Note from site admin: Sorry, but the photo which was attached to this post is no longer available.
#2

Hi William, and welcome!

The "39-6173" number you see is the part number of the tube layout sticker; it is not the model number of your radio.

The correct model number is TP-52. These were also advertised as Model UA-52P.

This radio was also marketed under the Simplex name. I suspect Simplex probably designed the set.

Has the part of your radio that is red been painted? The TP-52 was advertised as being made of white Beetle with a black base. The only photo I have ever seen of one is in a white/black color scheme.

At any rate, that is a really cool little set.

I sent you a PM on this subject.

--
Ron Ramirez
Ferdinand IN
#3

The red color appears to me to be original. The unit has some chips and underneath the red is black. I see no white on it at all.

A handwritten message on the top of it makes note of the University of Georgia whose colors are red and black and is dated 1940, apparently contemporaneous with a UGA football game. Would this have been manufactured in 1939?

Thanks for the info.
#4

Hmmm...very interesting. So now a color variation to the TP-52 has been confirmed.

Yes, it would have been manufactured around the summer of 1939.

Nice find!

Edit: I should add that those knobs are not original to the set.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco Model 80 Transformer resistance
The DC resistance of the primary is 8 to 9 Ohm.morzh — 07:54 PM
Philco Model 80 Transformer resistance
I have a feeling the primary winding on the power transformer is bad. My resistance reading on the primary side is 9 ohm...Mike L — 07:48 PM
Rusty Tuning Condenser
I would try Naval Jelly and use a soaked pipe cleaner to get it where it needs to go.RossH — 06:56 PM
38-10T chassis Restoration begins
Hello Dconant , they sold mica to use as a insulator between transistors and their heatsinks too. Rob I will remove th...radiorich — 02:52 PM
38-10T chassis Restoration begins
Thanks for the info guys. I always wondered why the use of mica. Now I know.dconant — 01:52 PM
38-10T chassis Restoration begins
Most common plastics have a dielectric constant in the 3-4 range whereas mica is around 6. This means that even if you w...Steve D — 01:46 PM
38-10T chassis Restoration begins
It is acceptable but not desirable. Plastic is not an approved cap dielectric, and even though a reasonably thick piece...morzh — 11:52 AM
38-10T chassis Restoration begins
I have a question about the mica sheets. I thought I saw somewhere on the Phorum where someone used thin plastic report ...dconant — 10:44 AM
38-10T chassis Restoration begins
Yes, you should carefully remove the mica sheets from the trimmers otherwise you risk trapping foreign material in the t...RodB — 10:34 AM
American Bosch Model 802 auto radio
Hi Joe, Thank you again. The American Bosch Model 634A has the same tube lineup as my Model 802 and the parts layout dia...Antipodal — 03:09 AM

[-]
Who's Online
There are currently 3361 online users. [Complete List]
» 5 Member(s) | 3356 Guest(s)
AvatarAvatarAvatarAvatar
Avatar

>