Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

39-6173 Bakelite
#1

I am a complete novice here and have one Philco radio with 39-6173 on a sticker on the inside of the cabinet and AX16093 stamped on the chassis.

I'd like to know what I have. Picture below.

Thanks...and if I need to do some remedial reading, just point me to the sources.

Note from site admin: Sorry, but the photo which was attached to this post is no longer available.
#2

Hi William, and welcome!

The "39-6173" number you see is the part number of the tube layout sticker; it is not the model number of your radio.

The correct model number is TP-52. These were also advertised as Model UA-52P.

This radio was also marketed under the Simplex name. I suspect Simplex probably designed the set.

Has the part of your radio that is red been painted? The TP-52 was advertised as being made of white Beetle with a black base. The only photo I have ever seen of one is in a white/black color scheme.

At any rate, that is a really cool little set.

I sent you a PM on this subject.

--
Ron Ramirez
Ferdinand IN
#3

The red color appears to me to be original. The unit has some chips and underneath the red is black. I see no white on it at all.

A handwritten message on the top of it makes note of the University of Georgia whose colors are red and black and is dated 1940, apparently contemporaneous with a UGA football game. Would this have been manufactured in 1939?

Thanks for the info.
#4

Hmmm...very interesting. So now a color variation to the TP-52 has been confirmed.

Yes, it would have been manufactured around the summer of 1939.

Nice find!

Edit: I should add that those knobs are not original to the set.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Samlex heavy-Duty bench supply filter question
Hello Everyone, I have one of my Heavy-duty bench powersuplies made by Samlex it's 13.8 volt dc 20-25 amp supply. What I...radiorich — 11:24 PM
Looking for place to donate unique Philco Philco J-1930 Prototype
It's a Glaser Sears changer which Philco's engineers thought was an upgrade over a VM, but in retrospect I'd prefer the ...jeibner — 10:39 PM
AC/DC Transformer-less Sets
Joseph, Thank you for the confirmation. I knew that there must be more to the Transformer-less AC/DC radios than the ...PeterN — 10:30 PM
AC/DC Transformer-less Sets
Good evening, folks. Power station engineer here! The east coast had pockets of DC-only power well into the twentieth...jrblasde — 10:11 PM
AC/DC Transformer-less Sets
Model 40 does not have a rectifier, so it would be a DC only model. This however does not say anything about using...morzh — 08:01 PM
AC/DC Transformer-less Sets
I was wondering if anyone knows if these AC/DC transformer-less sets were actually used on 110v DC anywhere, and when. ...PeterN — 06:35 PM
Looking for place to donate unique Philco Philco J-1930 Prototype
Given the 1960s vintage, it is likely that the cartridge is ceramic, likely more stable. The changer looks like a Voice...MrFixr55 — 05:03 PM
Jackson 665 j2 schematic request
FIXED!daveone23 — 03:55 PM
Bakelite crack repair - what is best epoxy?
Thanks everyone. I appreciate you sharing your experience and looks like I'll work with the 24 hr two part clear epoxy....de371 — 10:25 PM
Jackson 665 j2 schematic request
Without a schematic its going to be hard tracing the wire wound spool resistors.daveone23 — 05:21 PM

[-]
Who's Online
There are currently 4859 online users. [Complete List]
» 3 Member(s) | 4856 Guest(s)
AvatarAvatarAvatar

>