Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Bakelite capacitor block
#1

Restoring a Philco 650 and have 6 of the bakelite capacitor blocks to rebuild. I used to go to the Philco site where there was a section of diagrams showing internal wiring for the different blocks. With the remake of the site the list and the diagrams are gone. Anyone know where the information exists?

The other parts values are missing as well. Help.

Thanks.
#2

Find it here  
http://philcoradio.com/phorum/showthread.php?tid=14964

The book was just listed very good book too   Icon_thumbup
http://philcoradio.com/phorum/showthread.php?tid=16946

Sam

Some day, and that day may never come, I will call upon you to do a service for me. But until that day, accept this justice as a gift
mafiamen2
#3

Sam,

Thanks so much. I'm in your debt God Father.

John
#4

If you're referring to the Philco Repair Bench, try the Wayback Machine. The entire old site is archived.

https://web.archive.org/web/201603242327...lokcap.htm

Blessings,
Jeff W.
Jonesboro, Arkansas

http://jeffsradios.weebly.com

God loves you as you are, not as you should be, because none of us are as we should be. - Brennan Manning
#5

Thanks Jeff. Great find.
#6

(07-18-2017, 07:47 AM)jmac3ky Wrote:  Thanks Jeff. Great find.

I'm afraid I can't take credit. Someone else here on the Phorum pointed it out recently.

Once I saw it, I immediately went through all the archived pages and saved PDFs as a reference. Icon_thumbup

Blessings,
Jeff W.
Jonesboro, Arkansas

http://jeffsradios.weebly.com

God loves you as you are, not as you should be, because none of us are as we should be. - Brennan Manning
#7

Chuck is in the process of updating his Philco Repair Bench website so the info should all reappear there in time.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM

[-]
Who's Online
There are currently 5134 online users. [Complete List]
» 3 Member(s) | 5131 Guest(s)
AvatarAvatarAvatar

>