Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 650 Chairside Radio
#1

I just acquired a Philco model 650 Chairside radio. Eight ( 8 ) tubes , original knobs (Yea!) and cabinet intact. I cannot locate ANY data on this radio. I also find the radio interesting as it had no grille cloths ... the outlet grills on all sides were backed by "baffle boards" ca. 1/4 inch from the inside cabinet. Unfortunately, the original speaker(s) were replaced by more moden permanent magnet type speaker.

Any and all information on this interesting radio will be greatly appreciated.

Regards, all,

Frank
#2

Hi

Great acquisition! I had one of those a few years ago...wish I had kept it.

I have some info on the 650RX here:
http://www.philcoradio.com/gallery/1936a.htm#an

I seem to recall that the separate speaker cabinet originally used a permanent magnet speaker, and it used a choke instead of a field coil.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently 2487 online users. [Complete List]
» 1 Member(s) | 2486 Guest(s)
Avatar

>