Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Antenna connections
#1

Have a restored 38-610 console and am looking to connect antenna(s) for broadcast and shortwave reception.
Looking at the antenna terminals, have a "red", "black", "grnd" and "4". Labeled 1,2,3&4 respectively.
Currently have a jumper-bar between "black"(2) and "grnd"(3). As I recall, the jumperbar had something to do with a "short" antenna. Not sure of what I will use for antenna(s) but need to understand what the set wants first...
Also what impedance does the radio look for? 50 ohms?, 300?

Any info appreciated.
tim
#2

I'll take it to be a mystery...
guess I'll experiment
#3

I'll take a little stab at it. Looking at the 37-610 schematic it looks like jumpering 3 and 4 allows connection of a balanced antenna (dipole/doublet) at 1 and 2. Flipping the jumper over to 2-3 should allow a random-length single wire to be connected at 1.

Impedance wise you can guess the balanced connection to be in the 50-100 range and the single wire connection to be >600 ohms up to a few k-ohms.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
HiFi (Chifi) tube amp build - but my own design.
Tim, nice write up and thanks for sharing !! Sincerely Richardradiorich — 02:47 AM
HiFi (Chifi) tube amp build - but my own design.
Well, this was a real "Hum-Dinger" :lol: ! This will be kinda long, but hopefully it will help others having t...TV MAN — 01:55 AM
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM

[-]
Who's Online
There are currently no members online.

>