Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Still '' ANOTHER'' Deforest Crosley
#1

They warned me ,, when I started in this radio collecting hobby, that I would get hooked,
but I didn't listen to them.
  Well this  is the third Deforest Crosley this month.
 It is a model 8D991, and supposedly  rare.
 I tested the 6X6 eye tube and it glows OK, not bright , but livable.
  Of course the cabinet has to be done. The radio has a beam of light dial which I am looking
forward to seeing in action.
 Here are some photos 
 Dan in Calgary


Attached Files Image(s)
                   

   Living in Calgary Alberta
#2

Wow, That veneer is super nice..
I love that dial too... Its so.... BIG! Icon_lol

Icon_smile

Times I have been electrocuted in 2021
As of 1/01/2021
AC: 4 DC: 1
Last year: 6
#3

Once properly refinished, it will be a real looker.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
#4

WOW and double WOW I am with Kirk I love it!
#5

Dan;
  Your set is called the "Liszt", I have that set's twin brother called the "Brahms" model, the difference is that the "Brahms" has motorized tuning which they charged an extra $10 for, other then that it's the same as the "Liszt". Your cabinet is a little better then mine, mine needs some chipped veneer repaired on the top, and mine is missing two of the knobs, the outside ones I think. In terms of rarity I'm not so sure, I've seen at least three Deforest-Crosley "Liszt" models for sale on craigslist sites in my region over the past two years, the last one being in the Victoria area. Unfortunately some busy body decided that the four original controls were not enough and added two extras, right through the front panel, next to the band switch. I can't recall seeing another "Brahms" model but I must have seen at least one for sale, I have seen at least two of the "Rogers" equivalents of the 10 and 11 tube chassis models. It stands to reason that the non motor drive version would be more common since it was less expensive, $10 was enough to buy a five tube AC/DC in the pre war years.
Regards
Arran
#6

I just finished recapping this one and I find that the 6X6 tube is quite good,which is unusual.
 It plays very good, and the dial is nice.  Here are a couple of photos of the tube.
  Dan in Calgary.


Attached Files Image(s)
       

   Living in Calgary Alberta




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
38-10T chassis Restoration begins
Hello Dconant , they sold mica to use as a insulator between transistors and their heatsinks too. Rob I will remove th...radiorich — 02:52 PM
38-10T chassis Restoration begins
Thanks for the info guys. I always wondered why the use of mica. Now I know.dconant — 01:52 PM
38-10T chassis Restoration begins
Most common plastics have a dielectric constant in the 3-4 range whereas mica is around 6. This means that even if you w...Steve D — 01:46 PM
38-10T chassis Restoration begins
It is acceptable but not desirable. Plastic is not an approved cap dielectric, and even though a reasonably thick piece...morzh — 11:52 AM
38-10T chassis Restoration begins
I have a question about the mica sheets. I thought I saw somewhere on the Phorum where someone used thin plastic report ...dconant — 10:44 AM
38-10T chassis Restoration begins
Yes, you should carefully remove the mica sheets from the trimmers otherwise you risk trapping foreign material in the t...RodB — 10:34 AM
American Bosch Model 802 auto radio
Hi Joe, Thank you again. The American Bosch Model 634A has the same tube lineup as my Model 802 and the parts layout dia...Antipodal — 03:09 AM
38-10T chassis Restoration begins
hello everyone, I know it has been a while since I have posted about this radio but finally got chance work on it . I ...radiorich — 02:45 AM
Rusty Tuning Condenser
You could soak the fins in vinegar. You have to be careful if any pot metal is involved because the vinegar will dissolv...RodB — 09:20 PM
Rusty Tuning Condenser
Hello, I have a Philco 91 where the tuning condenser fins are rusty. I magnet sticks to them so they can't be aluminium....dconant — 05:50 PM

[-]
Who's Online
There are currently 3480 online users. [Complete List]
» 2 Member(s) | 3478 Guest(s)
AvatarAvatar

>