Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

GE Model 200
#1

Working on a GE Model 200.. Question

How do you get the glass out without breaking??

See pictures..

[Image: https://farm5.staticflickr.com/4447/3674...2236_b.jpg]

[Image: https://farm5.staticflickr.com/4484/3741...fa6c_b.jpg]

Thanks

Skip...
#2

I believe,, they are clips-- that flip open---out-----BUT could be __WRONG,,,,and they JUST ,,lift a little to get glass out??????//// they also look like fansworth clips,,,with a little wedge in them ,,to hold that main part tight,,and down ,or against the glass,,,,,Can't really tell from this point of vision,,,----hope that may HELP-----CHEERS
#3

Yes.. Was able to get glass out . One clip broke on right side and was able to slide glass from other two..

Thanks All

Skip...




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
New Philco Repair Bench
I am sure this is the archive, and not the Chuck's site.morzh — 09:50 PM
Made mistake & did not label connection
It's not like we are good friends with that wire and can tell it from other ptetty identical looking wires. Why'n't you...morzh — 09:49 PM
Made mistake & did not label connection
I'm not sure why that wire wasn't covered in the video. I'm pretty sure the 6A8 won't work until that pin is grounded. Y...RodB — 09:47 PM
Made mistake & did not label connection
You'll have to forgive me, I am not sure what you mean.  Can you explain what you are really saying.  If anyone does not...georgetownjohn — 08:05 PM
Made mistake & did not label connection
Those are details better left to the ones who know. Maybe you disconnected the wrong end of the wire.RodB — 06:22 PM
Made mistake & did not label connection
Maybe this is starting to make some sense in my hard head.  Is this why the wire in question was not in the great Ron Ra...georgetownjohn — 04:34 PM
Made mistake & did not label connection
I was correct with the 6A8 pin connection's, 7 and 8 are connected to ground as well as the tube shield (the broken line...RodB — 02:41 PM
Made mistake & did not label connection
What does the dotted line representing that surrounds the tube in the schematic?georgetownjohn — 02:17 PM
Made mistake & did not label connection
Hello John, I have been there either label got lost or was not labeled ! Sincerely Richardradiorich — 02:15 PM
Made mistake & did not label connection
Sorry, it is a Philco 37-640.  Does that help?--Johngeorgetownjohn — 02:14 PM

[-]
Who's Online
There are currently 4851 online users. [Complete List]
» 1 Member(s) | 4850 Guest(s)
Avatar

>