Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Trying to identify model number
#1

Greetings folks!  I picked up this Philco at a garage sale for $30 the only problem is I've been searching for the proper model number since the sticker was torn off of this one.  Any help is greatly appreciated!


Attached Files Image(s)
               
#2

Welcome to the Phorum!

To me it looks like 1937 model, 5 tubes, AC - I'd bet 37-610J.

http://philcoradio.com/gallery2/1937a/#Model_37-610J
#3

Hi and welcome,
+1
Are you going to be putting humty dumpty back together again?? Note the to tubes on the right are reversed the 5Y4 goes on the transformer and the 6F6G should be fitted to the chassis.

Service info can be found here: http://www.nostalgiaair.org/Resources/209/M0013209.htm
It's a code 121.

Here's one that Kelly went a little crazy on, it's a code 122. The difference being the 5Y4 mount to the chassis rather than the top of the power transformer.
http://philcoradio.com/phorum/showthread.php?tid=17485

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#4

(11-17-2017, 02:33 AM)Nathan Slingerland Wrote:  Welcome to the Phorum!

To me it looks like 1937 model, 5 tubes, AC - I'd bet 37-610J.

http://philcoradio.com/gallery2/1937a/#Model_37-610J

Thanks I'm glad I found this Phorum I had no idea what I was getting myself into when I picked it up.  Thanks for the info I appreciate it.
#5

Welcome to the Phorum!
Icon_wave
#6

(11-17-2017, 01:45 PM)Radioroslyn Wrote:  Hi and welcome,
+1
Are you going to be putting humty dumpty back together again?? Note the to tubes on the right are reversed the 5Y4 goes on the transformer and the 6F6G should be fitted to the chassis.

Service info can be found here: http://www.nostalgiaair.org/Resources/209/M0013209.htm
It's a code 121.

Here's one that Kelly went a little crazy on, it's a code 122. The difference being the 5Y4 mount to the chassis rather than the top of the power transformer.
http://philcoradio.com/phorum/showthread.php?tid=17485

I'm going to try or give it a good effort. I'm sure this unit has had previous work done I've been searching for months trying to identify it by pics and schematics so with this new info I've got somewhere to start now.  I haven't touched anything on this unit except wipe the dirt off the tubes I cleaned up the cabinet a bit and added a plexiglass window.


Attached Files Image(s)
   
#7

Chassis looks pretty original except that the three filter and mounts have been removed. Replacement tubulars where added ( the two Solar and the one over by the power transformer). You are missing the dial which repros are available and the fastener that holds it in place  It's a bit of an shape but was used for several years so it shouldn't be impossible to find. Along w/the grommets for the sub chassis.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
PT-6 finished!!
I agree with Ron. That’s how my 49-906 behaves. That’s why I’m curious if the bulb stays at full brightness if the recti...jrblasde — 07:54 AM
462ron
I don’t know exactly how dim your pilot gets but this is the typical of the response of many transformerless AA5s where ...462ron — 07:38 AM
Philco Battery-WWII vintage
Well Philco did start out in the lead acid battery manufacturing business, and I think that they were still doing so dur...Arran — 12:06 AM
Philco model 38 code 121 not receiving signal.
It is odd that they chose the autodyne mixer/oscillator in one version of this set, with the #15 tube, but chose to use ...Arran — 11:02 PM
Information on the Other Front Runners of the Era
It's not  philco but I use it quite often for Marconi radios which are Canadian. It is just another resource for u...Dan Walker — 10:25 PM
Zenith H725
Glad to hear the radio is back home. David :clap:David — 08:47 PM
Zenith H725
A great ending to the H 725 saga. I would feel all warm and fuzzy. PaulPaul Philco322 — 07:13 PM
Philco model 38 code 121 not receiving signal.
Hello everyone!  I've been working on a Philco 38 farm radio with the code 121 version chassis. As you all may know thi...Stormlord5500 — 06:36 PM
PT-6 finished!!
It’s a 1941 model. I won’t be using it enough to justify figuring out. All that’s left is getting the knob I have on or...bridkarl — 06:21 PM
PT-6 finished!!
I have heard of some people adding current limiting resistors ahead of the heater string in AC/DC sets but I never bothe...Arran — 06:16 PM

[-]
Who's Online
There are currently no members online.

>