Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Model ID, 70, 90 ?
#1
Information 

New member with post name “robark”. Real name Robert Barker, I generally go by Bob.

I have been collecting for 74 years and have a large collection from crystal sets, many battery radios, Grebe Synchrophase (3), AK breadboards (3 or 4), Radiolas IV, 20, 35, some Philcos, and much more. My first radio was a one tube set I built myself that ran on flashlight batteries and used a 6G6 tube. I live in Stamford, CT and would be pleased to meet with collectors from anywhere. An open invitation to all radio fans.

My immediate problem is the identification of a Philco chassis that looks like it might be a 70 or 90 but doesn’t seem to be either. The tube compliment is as follows.
24 56 24 24 56 56 56 47 80. At least, those are the tubes I found plugged into the set. No labels anywhere. I need a schematic but can’t find a model with this tube setup. Any help would be appreciated.

 I also have 2 or 3 junked Philco 60’s. If anyone needs a part from one of them they can have it, free, of course.
 
Bob
#2

Hello Bob, and welcome.

You must have a 90 since it has nine tubes. The 56 is a substitute for a 27, and it appears to me that someone substituted 56s for every 27 in your set.

Most likely this schematic will match your set:

http://www.philcoradio.com/images/phorum/schem/90b.jpg

Good luck.

--
Ron Ramirez
Ferdinand IN
#3

Thanks a bunch. That will help me a lot.
Bob
#4

Welcome to the Phorum!
Icon_wave
#5

Hi Bob and welcome!

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

[-]
Who's Online
There are currently no members online.

>