Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Northern Electric 1121
#1

I am picking up this one next week.
 It has 11 tubes with push pull 6V6 tubes and a 5X4 for a rectifier.
Five bands, and a nice cabinet. It is called  the ''London''
 I already have the '' Bombay'' [last photo] which I have refinished.
  Just like a kid at Christmas I can't wait.
 Dan in Calgary


Attached Files Image(s)
               

   Living in Calgary Alberta
#2

Dan;
   It looks like they used a piece of TenTest/Donnaconda/Homasote board over the back of the speaker compartment, which is still available should anyone need some. 
Regards
Arran
#3

Nice find Dan,

I had a Vimy. I gave it to a friend. I don't know if it survived the divorce.

cheers
#4

Dan;
    Your Northern Electric "London" looks like it was the recipient of a strip n' clearcoat job, the dial also looks like you may have to get a replacement made at radiodaze. Those mid 30's N.E sets are notorious for their use of water based paint on their dials, lucky that Radiodaze can probably use a scan of the " Bombay" dial as a basis for the missing lettering.
Regards
Arran




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM
Philco 16B Parts
Hi Dan, Mike is correct, there's a lot of painted stuff on the chassis but it looks pretty good. The sm is all there,sp...Radioroslyn — 03:50 PM

[-]
Who's Online
There are currently 3991 online users. [Complete List]
» 3 Member(s) | 3988 Guest(s)
AvatarAvatarAvatar

>