Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

philco 46 200 code 122
#1

So I picked up this little Philco and I guess it is a different tube set than the more popular model. It uses 7A8 7B7 7C6 Tubes with the 35Z5 and 50L6GT. 

The schematic on Nostalgia Air has 14B6 14A7 7A8 tube. So I guess as tubes were a good deal, or overstock, etc......especially after the War there were several versions of set in similar cabinets. Maybe more of this on the cheaper sets.

Looking for a "freebie" schematic on my code 122 versions. Did some searches with no luck.

Any ideas?

Thanks.

Paul

Tubetalk1
#2

The 7xx series tubs were actually 6.3v, same as their 6xx octal brethren... Same for 14 volt actually 12.6... For awhile Sylvania did list the 7xx as 7v but that idea was shelved in either late 40s or early 50s...

Except for 7A8, the 7xx tubes should have same basing as 14xx so that schematic should be useable...

Tom
#3

Have a look here Paul might have the schematic you need. Good luck.
http://www.audiophool.com/Philco.html




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently no members online.

>