Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

philco 46 200 code 122
#1

So I picked up this little Philco and I guess it is a different tube set than the more popular model. It uses 7A8 7B7 7C6 Tubes with the 35Z5 and 50L6GT. 

The schematic on Nostalgia Air has 14B6 14A7 7A8 tube. So I guess as tubes were a good deal, or overstock, etc......especially after the War there were several versions of set in similar cabinets. Maybe more of this on the cheaper sets.

Looking for a "freebie" schematic on my code 122 versions. Did some searches with no luck.

Any ideas?

Thanks.

Paul

Tubetalk1
#2

The 7xx series tubs were actually 6.3v, same as their 6xx octal brethren... Same for 14 volt actually 12.6... For awhile Sylvania did list the 7xx as 7v but that idea was shelved in either late 40s or early 50s...

Except for 7A8, the 7xx tubes should have same basing as 14xx so that schematic should be useable...

Tom
#3

Have a look here Paul might have the schematic you need. Good luck.
http://www.audiophool.com/Philco.html




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
I use a pair of Mastercraft brand DMMs from Canadian Tire, from what I read most of those DMMs use the same main chip re...Arran — 02:36 PM
Philco model 38 code 121 not receiving signal.
Thank you sir. Yes I feel good and also relieved because this one's been weighing on me a bit.Stormlord5500 — 11:18 AM
Philco model 38 code 121 not receiving signal.
It feels good don't it? Good luck on the rest.Paul Philco322 — 11:06 AM
Philco model 38 code 121 not receiving signal.
I've reinstalled the coil. Now IT'S ALIVE!!!!!! I fired up my TinySA on signal generator mode and set it to 1400Kc and ...Stormlord5500 — 11:01 AM
Philco model 38 code 121 not receiving signal.
Yes, Walmart, right up there with Fluke.RodB — 11:00 AM
PT 6 chassis screws size???
it certainly won't be metric! SAE threads were all that was known then. Take care, - GaryGarySP — 10:58 AM
Philco model 38 code 121 not receiving signal.
I think this thing is way more accurate than my Walmart DMM. :DStormlord5500 — 08:19 AM
Philco model 38 code 121 not receiving signal.
Thankyou for the kind words sir. I double checked it with my component tester and it read 2.7 ohms at .02mH.Stormlord5500 — 08:14 AM
PT 6 chassis screws size???
Hello bridKarl, that sounds right or maybe 8/32 . Sincerely Richardradiorich — 01:00 AM
PT 6 chassis screws size???
Have this done except for missing chassis screws. It looks like 1 inch 6/32 sheet metal screw may work but can anyone s...bridkarl — 10:32 PM

[-]
Who's Online
There are currently 1054 online users. [Complete List]
» 1 Member(s) | 1053 Guest(s)
Avatar

>