06-20-2018, 12:20 PM
Ok thanks Ron, I have already ordered some zebrawood veneer off eBay. I just never heard eBay, called e-pay before.
Philco 41-295X 4 band radio.
I'm 67 years old, in north Idaho.
Started the restore on my Philco 40-180.
06-20-2018, 12:20 PM
Ok thanks Ron, I have already ordered some zebrawood veneer off eBay. I just never heard eBay, called e-pay before.
Philco 41-295X 4 band radio. I'm 67 years old, in north Idaho.
06-20-2018, 12:52 PM
I don't care for their business model so the disrespect is intentional. But, some sellers are worth doing business with. Usually once I make a purchase, I keep the sellers site/address so I can deal directly with them.
06-20-2018, 10:14 PM
I've never had a problem with eBay, but have with PayPal. About 8 yrs ago, they sent me a bill for $270., but refused to send me an invoice so I could see what the bill was for. They finally sent it to collections. after 8 years, I have never payed it, and they still refuse to send me an invoice.
Michael Philco 41-295X 4 band radio. I'm 67 years old, in north Idaho.
06-21-2018, 02:38 PM
I’m not sure I have it down on how to post pictures but hopefully I got it right.
I tried to post a before and after photo of my Philco 40-180 cabinet. I had to totally replace the veneer strips on either side of the speaker. I think the replacement veneer is a pretty close match to the original!
06-29-2018, 10:30 PM
Alright, I received the zebra-wood veneer a couple days ago, managed to get it cut.installed it yesterday, turned out pretty good.
[attachment=16665] I spent the week with grain filler, and sanding sealer, then the zebra-wood veneer, today I sprayed 2 coats of Mohawk ultra flo clear Lacquer. Tomorrow a little light sanding, then 2 more coats of lacquer. Then see where I stand. heres a picture of one side, got too dark to do the other side. [attachment=16666] Michael Philco 41-295X 4 band radio. I'm 67 years old, in north Idaho.
06-29-2018, 11:43 PM
I never got and answer about the plastic piece that was on the inside of the top of the cabinet, all that was there was the 4 corners 2 on each side. Looks like it was 4in wide and went across from one side to the other. It was brown, does anybody know what that was?
Michael Philco 41-295X 4 band radio. I'm 67 years old, in north Idaho.
06-30-2018, 11:01 AM
Methinks it's missing the ant loop for the high SW band.
When my pals were reading comic books I was down in the basement in my dad's workshop. Perusing his Sam's Photofoacts Vol 1-50 admiring the old set and trying to figure out what all those squiggly meant. Circa 1966 Now I think I've got! Terry
06-30-2018, 11:31 AM
(06-30-2018, 11:01 AM)Radioroslyn Wrote: Methinks it's missing the ant loop for the high SW band. That makes sense, I have never seen one listed anywhere. Have any ideas where I might find one? Philco 41-295X 4 band radio. I'm 67 years old, in north Idaho.
08-18-2018, 01:16 PM
Sorry I haven't been back on here, been busy looking for a new house, put both radios on the back burner till after we move. We close on the new house on the 24th, so after the move, I will have a 36X48 shop to work in. Will get back to them then just a little work to do on the 41-295, and still need to work in the chassis for the 40-180. Both cabinets are done.
Michael Philco 41-295X 4 band radio. I'm 67 years old, in north Idaho.
« Next Oldest | Next Newest »
Users browsing this thread: 1 Guest(s) |
![]() |
![]() |