Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Any Philcos that contain asbestos?
#1

Howdy guys -

Are there any Philco radios that contain asbestos?

Thanks,
Paul
#2

This is a good question and as such, I split it into its own thread.

Offhand, I can think of several. The 1935 version of the 16RX control unit has asbestos inside the cabinet.

Most if not all of the little Transitone/Philco Transitone models with five tubes crammed onto a tiny chassis have a sheet of asbestos under the chassis.

And there are probably others which I can't think of right now.

--
Ron Ramirez
Ferdinand IN
#3

Thanks Ron!

Would that then include the 35' 16x console?  Naturally, I have one and would want to be aware.  

Is the sheet in these cases glued down to the cabinet?  

Paul
#4

I used to own the 1935 version of the 16X, and it had no asbestos.

In the sets I have seen that had asbestos, the sheet was generally stapled to the cabinet.

--
Ron Ramirez
Ferdinand IN
#5

I think when I got two of 40-120 (or 40-125) that I bought for Kirk at Sam's expense Icon_smile , cheap, to get Kirk a speaker, there was asbestos inside.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
#6

41-226C ('The Sled') has it.

http://philcoradio.com/gallery2/1941a/#Model_41-226C
#7

Back then, they thought they were doing their part to prevent forest fires. Or urban fires.

I've heard of guys replacing the asbestos sheets with that gray high-temp engine gasket material. They made no mention as to how they disposed of the asbestos, however.

--
Ron Ramirez
Ferdinand IN
#8

Thanks for the info Ron. Very appreciated.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco Model 80 Transformer resistance
Just forget this number, it is useless anyway. Simply proceed with your project.morzh — 10:08 PM
Philco Model 80 Transformer resistance
My $0.02 is that it is a misprint. I tried to look up the value for the similar 84 and 37-84, and ther is no resistance...MrFixr55 — 09:51 PM
Philco Model 80 Transformer resistance
Thanks for the quick reply! Hmm...well that's good, so what am I seeing that's 1042 ohms on the schematic for the pow...Mike L — 08:46 PM
Philco Model 80 Transformer resistance
The DC resistance of the primary is 8 to 9 Ohm.morzh — 07:54 PM
Philco Model 80 Transformer resistance
I have a feeling the primary winding on the power transformer is bad. My resistance reading on the primary side is 9 ohm...Mike L — 07:48 PM
Rusty Tuning Condenser
I would try Naval Jelly and use a soaked pipe cleaner to get it where it needs to go.RossH — 06:56 PM
38-10T chassis Restoration begins
Hello Dconant , they sold mica to use as a insulator between transistors and their heatsinks too. Rob I will remove th...radiorich — 02:52 PM
38-10T chassis Restoration begins
Thanks for the info guys. I always wondered why the use of mica. Now I know.dconant — 01:52 PM
38-10T chassis Restoration begins
Most common plastics have a dielectric constant in the 3-4 range whereas mica is around 6. This means that even if you w...Steve D — 01:46 PM
38-10T chassis Restoration begins
It is acceptable but not desirable. Plastic is not an approved cap dielectric, and even though a reasonably thick piece...morzh — 11:52 AM

[-]
Who's Online
There are currently 4324 online users. [Complete List]
» 1 Member(s) | 4323 Guest(s)
Avatar

>