Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 111
#1

This started out as an unknown Philco I kept passing in the antique mall for a week or so. Personally I thought it might be a model 96, but it's hard to sneak a look at the insides of radios at this place. Tuesday this week I finally decided to get a good look at the radio and see what it was. Well, NO TAG! Looks like the tag has fallen off the set rather recently as the metal there is still quite shiny. Copped a feel of the tubes under the shield to try and count them... 10? 11?! Ok, this is definitely NOT a model 96! Cabinet looked great and even though it was priced at $185, the discount after paying cash brought it down to $166 after taxes. Looking through this site I am now certain I have a model 111 console from 1931. All the tubes in it are still good and it even still has four original globe type tubes in it! Now it will need a new cord and the speaker wires repaired, looks like a mouse attack.

Note from site admin: Sorry, but the photos which were attached to this post are no longer available.

No matter where you go, there you are.
#2

Jayce

That is an excellent example of a 111 highboy. Looks great! since it appears to have its original finish, with the original shading, that makes it even better. Congratulations on your find. Icon_biggrin

--
Ron Ramirez
Ferdinand IN
#3

Thanks! Hopefully it will sound as good as it looks when done. Had to buy another speaker for parts and the cone. This unit has one of the hard black paper cones that usually seem to tighten up into a drum skin with age. The other Philco speaker I found is the same unit, but uses a canvas speaker cone.

No matter where you go, there you are.




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Correct model 84 Ac plug an cord type
From what I read Philco went to using brown rubber power cords in 1936, so cloth was used in the 1935 and earlier models...Arran — 11:25 PM
Correct model 84 Ac plug an cord type
Hi Bruce, I have not worked on an 84, but in general, power cords for almost any radio prior to 1938 was cloth covered...MrFixr55 — 08:34 PM
Restoring Philco 38-14
OK, well, so after staring at the sch again, I realized the problem had to be the #12/12A padder. I put a scope on the o...morzh — 08:15 PM
Correct model 84 Ac plug an cord type
Hello Bruce, I mostly use brown far as my cloth powercords go ! Here is the plug that I have used bakelite Acorn style...radiorich — 08:05 PM
Correct model 84 Ac plug an cord type
Looking for as correct as can find the right Ac plug an the correct colored cloth line. Ive seen many old photos but mos...Bruce — 04:13 PM
Restoring Philco 38-14
Rod Two Y-caps make sense if you use them from L/N to the chassis; this is only makes sense in the transformer radios...morzh — 10:11 AM
Restoring Philco 38-14
Mike, I'm curious about a specific use of he Y cap. Lately I've seen a single cap across the power transformer primary. ...RodB — 09:01 AM
Restoring Philco 38-14
hello morzh , That sounds like a plan ! Sincerely Richardradiorich — 07:45 AM
Restoring Philco 38-14
Richard, It helped some, but I still had the whining when engaging the rear power strip (I did not realize it was fro...morzh — 07:07 AM
Restoring Philco 38-14
Hello morzh, Yes , that dreaded hum in my room where i do alighment I have my cable modem and router plus desktop plus ...radiorich — 11:25 PM

[-]
Who's Online
There are currently no members online.

>