Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco Console ID
#1

Hello all,
I hope I am posting this to the correct forum, if not please just remove it.

I am pretty new here, however I'm not new to radio restoration.  Mainly I've done military and communication type receivers and transmitter for the past 30 or so years...

I am returning a favor for my niece who gave me an E.H. Scott 510 by getting an old Philco console working for her.  I am pretty sure I have the correct schematic for the chassis, but I simply can not identify this specific radio.  I have found versions of the 118, the 18 and now a 59 that look very similar to it, but every time I think I've found it, I discover something a little different on the cabinet.

Can any of you Philco experts tell me what model and version this is?  If more photos are needed, let me know.  I hope the attachments comes through...  TIA!  Brian


Attached Files Image(s)
       
#2

Hi and welcome,

It is either an 18X or a 118X. How to tell the difference:

If it is an 18X, it will be AM only.

If it is a 118X (and I suspect it probably is), it will have the AM band on the dial plus SW frequencies of 4.2 to 12 mc (MHz) also on the dial.

Model 59 is a very small four tube table model radio which looks nothing like this console, so we can eliminate that from contention. Icon_smile

--
Ron Ramirez
Ferdinand IN
#3

Thank you Ron!  Yes, it does have the shortwave band, so we know it's not an 18X.  I saw a 59C posted somewhere that someone must have mislabeled since it looked like this one.
It seems the variations I've seen are the little emblems, or emblem at the top.  This one has two on each side of center (one missing), and I've seen some with one dead center at the top.  Just little things like that kept me from coming up with something that was identical!  Thanks again!

Brian
#4

I hate to be a problem child, however this is what I am talking about in some small variations.  These two are shown on the Philco site for the 118X.
The first link is identical to ours except for those two little musical emblems at the top.  The one in the link has only one in the center.
The second one is not very close, especially the top
UPDATE: I just found some more small variations in the cabinet that do not match either of these. Subtle, but certainly different.
http://philcoradio.com/gallery2/1935b/#Model_118X
http://philcoradio.com/gallery2/1935a/#Model_118X

Maybe this was common to have a certain version that had some random variations, but I just don't know.  I do think you are absolutely correct in that it is some version of a 118(x).

Regards,
Brian
#5

That set looks super, I would be tempted to leave cabinet alone, maybe a clean up, even with the wear looks very period. 

Good luck. 

Paul

Tubetalk1
#6

Thanks Paul!  Yes, it does look nice.  It belongs to my niece and I might just do some very light cosmetic work and be done with it.  I do have a lot of veneer and might replace the top as it looks pretty bad.  She is quite a collector, but does not work on them, so I told her to pick one and I'll get it going!

Brian




Users browsing this thread:
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently 3743 online users. [Complete List]
» 1 Member(s) | 3742 Guest(s)
Avatar

>