Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 116 repro dial scale
#1

Any comments offered for the reproduction Philco 116 dial scale as sold by Radio Daze? Is the plastic clear enough for the dial lamps to shine through? Are there better repros available?
#2

Yes - a translucent repro dial from Mark Oppat.

http://www.oldradioparts.net/dials1.html
(scroll down towards the bottom of the page to find the 116 listing)

The Radio Daze dials are too pale yellow, they look like an obvious repro.

If you don't mind a laminated dial scale with some limitation to the light that can pass through, I think I have a copy of the artwork around here somewhere. I've made my own laminated dial scales. I make mine more of an amber color so they do not stand out like the proverbial sore thumb, but they still do not pass as much light as Mark's translucent scales do.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM

[-]
Who's Online
There are currently 1445 online users. [Complete List]
» 3 Member(s) | 1442 Guest(s)
AvatarAvatarAvatar

>