Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Cleaning a turntable stylus?
#1

This may be a little off-topic, but lately, I've been struggling with stuttering from my vinyl. I've come to the realization that maybe I need to clean my stylus and cartridge, but I see quite a few different opinions on the topic.

https://soundwiz.net/blog/clean-turntable-needle/
This article kinda hinted me towards getting either some sort of sponge or some sort of gel solution rather than just a brush.

What are your guys take on cleaning a turntable and its stylus? I'd love a few opinions.
#2

I always like to start with a good inspection of the needle. Then you know what you're up against. Of course I have access to magnifying equipment.
#3

Rasmus

are you talking about modern or vintage players?

If modern,

1) you placed in in a wrong forum - this is for Philco restorations. 2) You might go in the "Vintage Hi-Fi" one and post it there.

Even though it is against the policy, I'd say that the best advice for modern turntables and cartridges you will get on AudioKarma or similar places. We here more about really antique things.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM

[-]
Who's Online
There are currently 1293 online users. [Complete List]
» 2 Member(s) | 1291 Guest(s)
AvatarAvatar

>