1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
37-10 volume control
PencilmanCA73
Junior Member
**
Posts: 3
Threads: 1
Joined: Jul 2018
City: Olympia State, Province, Country: Washington
#1

12-03-2018, 10:50 PM
I am working on a Philco model 37-10 that has a bad volume control, part number 33-5158. I am having trouble tracking a replacement down. Any help finding one will be appreciated. I had a link to a site that had an awesome selection of controls but I lost that link when I was saving it to my bookmarks.
Find
klondike98
Phorum Moderator
******
Posts: 5,088
Threads: 270
Joined: Nov 2012
City: Wilsonville State, Province, Country: OR
#2

12-03-2018, 10:58 PM
Welcome to the Phourm!
Icon_wave

If you don't find a replacement, good option is to contact Mark Oppat and he can probably fix it or will have something for you.
Cheers,
Bob
[Image: https://www.dropbox.com/s/5m63ib99yfx2eg....jpg?raw=1]
Bob's Restorations Web Page
Website Find
Radioroslyn
Phorum Expert
*****
Posts: 7,286
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#3

12-03-2018, 11:41 PM
Welcome!
Mark O more than likely can build a pot for you. I just got a similar one for my 116B it was abt $25.

GL
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
Find
PencilmanCA73
Junior Member
**
Posts: 3
Threads: 1
Joined: Jul 2018
City: Olympia State, Province, Country: Washington
#4

12-03-2018, 11:57 PM
Hi, Bob thanks for the welcome to the Phorum.

I will check Mark Oppat and see what he can do. The site I mentioned has an enormous selection of controls and models and includes a list of substitutes. I am doing this repair for my daughter. I am a retired electronics guy and it's been a while since I have done any work of this nature so I have been scrambling to find all of the equipment I need to do the job. Most parts have not been a problem.

I checked your restoration page, nice work.

Jim
Find
PencilmanCA73
Junior Member
**
Posts: 3
Threads: 1
Joined: Jul 2018
City: Olympia State, Province, Country: Washington
#5

12-04-2018, 12:00 AM
Thanks, Terry, I will check Mark Oppat.
Find
« Next Oldest | Next Newest »




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM

[-]
Who's Online
There are currently 4030 online users. [Complete List]
» 2 Member(s) | 4028 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration