Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 89 (code 121) parts list
#1

I have looked for this and hope I haven't missed it somewhere. Can anyone point me to a parts list for the Philco 89 Code 121 cathedral? There is a bottom view of the chassis showing parts in Riders 3-34 with the schematic on 3-33, but I cannot find a page telling me what the actual parts are. I am mainly wanting to know the capacitors before pulling the blocks out. I know I can look at the block numbers and figure it out, but sometimes you have to pull it to see the numbers. I see a parts list for the 89 code 123, but numbers are different.
Thanks,
Scott
#2

Welcome to the Phorum! Icon_wave

Here's a must view link: http://www.philcoradio.com/phorum/showth...?tid=15002 that has the evolution of the model 89 showing the changes in the circuits over the years. Ron, our founder, put this together and should be very helpful. It does not have a list of parts but the schematics are very readable.

Also try: http://www.audiophool.com/Philco.html where you can view Service Bulletins #146 and #146B. They have lists for the 121 and 123 respectively. you need to download the djvu reader to view the images. If you have trouble let me know.
#3

Thanks Bob,
I can make it with those very easily.
Thanks Again,
Scott




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco Model 80 Transformer resistance
Just forget this number, it is useless anyway. Simply proceed with your project.morzh — 10:08 PM
Philco Model 80 Transformer resistance
My $0.02 is that it is a misprint. I tried to look up the value for the similar 84 and 37-84, and ther is no resistance...MrFixr55 — 09:51 PM
Philco Model 80 Transformer resistance
Thanks for the quick reply! Hmm...well that's good, so what am I seeing that's 1042 ohms on the schematic for the pow...Mike L — 08:46 PM
Philco Model 80 Transformer resistance
The DC resistance of the primary is 8 to 9 Ohm.morzh — 07:54 PM
Philco Model 80 Transformer resistance
I have a feeling the primary winding on the power transformer is bad. My resistance reading on the primary side is 9 ohm...Mike L — 07:48 PM
Rusty Tuning Condenser
I would try Naval Jelly and use a soaked pipe cleaner to get it where it needs to go.RossH — 06:56 PM
38-10T chassis Restoration begins
Hello Dconant , they sold mica to use as a insulator between transistors and their heatsinks too. Rob I will remove th...radiorich — 02:52 PM
38-10T chassis Restoration begins
Thanks for the info guys. I always wondered why the use of mica. Now I know.dconant — 01:52 PM
38-10T chassis Restoration begins
Most common plastics have a dielectric constant in the 3-4 range whereas mica is around 6. This means that even if you w...Steve D — 01:46 PM
38-10T chassis Restoration begins
It is acceptable but not desirable. Plastic is not an approved cap dielectric, and even though a reasonably thick piece...morzh — 11:52 AM

[-]
Who's Online
There are currently no members online.

>