1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
Correct Knobs?
Radioroslyn
Phorum Expert
*****
Posts: 7,286
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#1

12-26-2018, 05:17 PM
on this 600 or 602? The volume seem to be pretty odd.


Attached Files Image(s)
   
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
Find
Ron Ramirez
Silent Key
*****
Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand State, Province, Country: Indiana
#2

12-26-2018, 05:35 PM
I can confirm it is correct - the 602 I had years ago had the same knob.
--
Ron Ramirez
Ferdinand IN
Find
Radioroslyn
Phorum Expert
*****
Posts: 7,286
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#3

12-26-2018, 08:45 PM
Tnx. I saw the one in the gallery which has the same knobs but seems like it's a one off job. Don't think I've ever seen those on any other Philco. Like the '36 bandswitch knob.
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
Find
Ron Ramirez
Silent Key
*****
Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand State, Province, Country: Indiana
#4

12-26-2018, 10:17 PM
Yup...

The 602C in the Gallery has an (incorrect) rosette knob for tuning. The 600C in the Gallery has the correct knobs.

It is odd, given Philco's penchant for pinching pennies, that they would design and implement a bandswitch knob that was only used in the latter half of the 1936 season. (Not to mention the off-on-volume knobs of the 600C and 602C.) But then again, Philco switched from black to brown knobs for the 1937 season, also. Very odd indeed.
--
Ron Ramirez
Ferdinand IN
Find
SteveG
Senior Member
****
Posts: 330
Threads: 40
Joined: May 2015
City: Sanger, CA State, Province, Country: California
#5

01-01-2019, 09:14 PM
Cute little radio!
Find
Phlogiston
Radio-Fixer-Upper
*****
Posts: 2,118
Threads: 112
Joined: Jun 2010
City: Medford OR (OR what?)
#6

01-02-2019, 02:02 PM
(12-26-2018, 10:17 PM)Ron Ramirez Wrote:  Yup...

The 602C in the Gallery has an (incorrect) rosette knob for tuning. The 600C in the Gallery has the correct knobs.

It is odd, given Philco's penchant for pinching pennies, that they would design and implement a bandswitch knob that was only used in the latter half of the 1936 season. (Not to mention the off-on-volume knobs of the 600C and 602C.) But then again, Philco switched from black to brown knobs for the 1937 season, also. Very odd indeed.

Maybe he made the knob for another use but switched it to this radio to save part/money. Just speculation, probably could not prove one way or the other.
"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
Website Find
« Next Oldest | Next Newest »




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM

[-]
Who's Online
There are currently 5050 online users. [Complete List]
» 1 Member(s) | 5049 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios