Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

RCA R39
#1

I have a lead on a RCA R39. Looks to be  a Canadian built radio in reasonable condition. 8 tube TRF. Are these especially desireable?
#2

It's probably a "Victor" rather then an RCA is it was sold in the Canadian market. I believe that the R39 is one of the microsyncronous models, which debut for the 1929 model year, and were carried over until 1931, they have a funny arrangement with the tuning capacitors in order to allow them to be aligned to synchronize with the dial scale. The RF section is usually a series of #26 tubes as RF amplifiers, followed by a #27 detector, so not much different then an RCA Radiola 18 electrically, the audio amp and power supply is on the bottom chassis. In terms of value, well they are decent sets, not as good as a superhet, but with push pull #45s, electrodynamic speaker, and a heavy cabinet, they sound good. They are also fairly common, I think that Victor/RCA built something like 400,000 units over three years across all the models, so they are probably middle of the road in terms of value. At one time some guys had a scam of taking the power supply/amp chassis out, and pedaling them to Japanese audiophools as Western Electric amplifiers and speakers, so they used to be worth more because of that, until word got around the Orient that they were being swindled, now they are back down to where most late 1920s and early 30s consoles are. Be careful lifting these though, it's a two many job, the ones with a phonograph in top is a three man job.
Regards
Arran
#3

Thanks Arran!




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM

[-]
Who's Online
There are currently 5189 online users. [Complete List]
» 3 Member(s) | 5186 Guest(s)
AvatarAvatarAvatar

>