Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

philco 16B
#16

Thanks for the info Mike, old posts above (posts #2 and 3, page 1, this thread) edited to reflect this fact.

--
Ron Ramirez
Ferdinand IN
#17

Good. I actually went to check it in my 2-year old thread about my 16 to make sure before I posted here.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
#18

Stall-U-Rated reports that Lasco #32 and #60 O-rings (Ace Hardware) also work in the Philco 16 dial drive mechanism.

--
Ron Ramirez
Ferdinand IN
#19

Buy assortment KIT from Harbor freight,,,,Metric or standard sizes,,,,Cheap they are
#20

OK so now I am confused. But what's new. I have not yet done the o-ring replacement on a model 16. This is somewhere in my future I suspect.
Am I understanding correctly that along with the Danco o-rings that I already purchased I will need another round gasket for behind the dial?
                                                               Thanks,
                                                                      Henry




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM

[-]
Who's Online
There are currently no members online.

>