Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

philco 16B
#16

Thanks for the info Mike, old posts above (posts #2 and 3, page 1, this thread) edited to reflect this fact.

--
Ron Ramirez
Ferdinand IN
#17

Good. I actually went to check it in my 2-year old thread about my 16 to make sure before I posted here.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
#18

Stall-U-Rated reports that Lasco #32 and #60 O-rings (Ace Hardware) also work in the Philco 16 dial drive mechanism.

--
Ron Ramirez
Ferdinand IN
#19

Buy assortment KIT from Harbor freight,,,,Metric or standard sizes,,,,Cheap they are
#20

OK so now I am confused. But what's new. I have not yet done the o-ring replacement on a model 16. This is somewhere in my future I suspect.
Am I understanding correctly that along with the Danco o-rings that I already purchased I will need another round gasket for behind the dial?
                                                               Thanks,
                                                                      Henry




Users browsing this thread:
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently 3060 online users. [Complete List]
» 1 Member(s) | 3059 Guest(s)
Avatar

>