Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco PT-25--BIG MESS
#16

Ron, I understand..Not blaming Chuck.. I'm sure that was all he had.. But I was hopeing he had more..

This thing is such a mess that I need as much info and parts layout I can get..Otherwise its going in garbage..

That would be a shame as the Case is really in great shape.. But getting frustrated


Skip
#17

I have a unrestored PT-30 I can shoot a pict of wiring. I believe tube lineup is same.

Tom
#18

Tom, Ok thanks .. I will send you a PM with my email address..

Thanks

Skip
#19

Still changing wires.. found many more crumbled.. looks like a complete rewire job.. NOT FUN..

Keeping me busy on these Long Snowy Nights.. Supposed to get 3-6 inches more tonight..

Skip
#20

That's what they promise.

It is mostly raining here now but looking like a bit of snow while it is falling, though it is melting while falling.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
#21

Ok I have a question.. The Cap across the AC line Part 25 Says its a .04 Should that be replaced with a Y2 or X2 cap.. I have a X2 at .047.. I know I can probably due away with it also..

[Image: https://farm8.staticflickr.com/7912/4733...ca82_b.jpg]


What do you guys think ?

Skip
#22

That's FBOM. It's just there to filter rf noise out before it get into the set. These days there's a lot of noise so not all that effective.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#23

(03-09-2019, 09:31 PM)Radioroslyn Wrote:  That's FBOM.

Я этого не понимаю. What is FBOM? Icon_think

--
Ron Ramirez
Ferdinand IN
#24

Ham logo Fine Business Old Man.
In short OK.
Similar to GLOM
Good Luck Old Man

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#25

Ok, Finished up the wiring .. Not the greatest job.. But radio works Great..

[Image: https://farm8.staticflickr.com/7921/4672...62a4_b.jpg]

When first powered on I had terrible motor boating across the band.. I forgot to Ground 2 of the tubes.. The 7B6 and 7B7.. After grounded set works with NO hum and no more motor boating.. On to alignment..


Skip
#26

Looks good!

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#27

Looks pretty tightgly packed under there, nice work.  Icon_smile

Paul

Tubetalk1
#28

Here is the finished radio.. Looks pretty good . Plays great..

[Image: https://farm8.staticflickr.com/7862/4744...6555_b.jpg]


On to the next..

Skip
#29

Looks very fine indeed. So patience paid off! Good job! Icon_clap

paul

Tubetalk1
#30

Yes. Fine job, Skip, fine job. Icon_thumbup

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently 3914 online users. [Complete List]
» 1 Member(s) | 3913 Guest(s)
Avatar

>