Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco Radio
#1

I have a Philco Model 46131 Radio it is not in to good condition I was wondering how I can find out how old it is and were can I see about restoring it. I found some other numbers on it and don't know what they mean maybe someone can help. On the back there is a number stenciled in the metal 80 205 09 also I found this number T23548 and I found this part no. 10613 A. Can anyone help?
#2

Well, 46-131 should be a 1946 model. I am not sure of any of the other numbers, however. Here is a website link which hs the Rider pages on it:http://www.nostalgiaair.org/PagesByModel/589/M0013589.pdf It is on the Nostalgia Air website. (Rider is an aftermarket schematic supplier of the period)

Of course this isn't much help, but there will be some other responses to help you!
Enjoy!
Scott

Old Cars, Old Radios, Old Pipes and Young Women... What more is there?
#3

Might this be the radio in question?

http://radioatticarchives.com/images/p/P...Dennis.jpg

I'm not sure who might be able to help in it's restoration, we'd need to know your location to help with that. However, I hope this identifies it for you.

Bill

Sent from my Pentium II on the AT&T Dial Network




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

[-]
Who's Online
There are currently 5001 online users. [Complete List]
» 1 Member(s) | 5000 Guest(s)
Avatar

>