1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
Philco Model 90 Tuning Dial
Jonathan Philco 41
New Member
*
Posts: 2
Threads: 1
Joined: Apr 2019
City: Huntsville State, Province, Country: Alabama
#1

04-05-2019, 09:37 AM
Hello friends. I just restored a Philco model 90. Turned out great. As with many of these, the tuning knob/dial slips when tuning. It turns but the dial does not. does anybody have any suggestions on how to fix this tuning bushing or where to obtain a new one?  Thank you.

Jon
Find
Radioroslyn
Phorum Expert
*****
Posts: 7,273
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#2

04-05-2019, 10:09 PM
Hi Jon and welcome,
Would have replied sooner  but it's been along time since I've serviced a model 90. So what's the problem? Is the tuning shaft pinching the inside of the dial hub correctly?? Is the tuning shaft worn badly so pinching mechanism can't grip the hub. Spring weak?
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
Find
Jonathan Philco 41
New Member
*
Posts: 2
Threads: 1
Joined: Apr 2019
City: Huntsville State, Province, Country: Alabama
#3

04-09-2019, 05:41 PM
Hi Terry . Sorry for the late reply. The radio is put back together. I can tune the radio if I push down on the tuning knob as I turn the tuning knob. I have two model 90's with the same problem. One is worse than the other however. It is irritating indeed. The restore turned out excellent however. Could you send me a private message so I can send you my contact information?
Find
« Next Oldest | Next Newest »




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Correct model 84 Ac plug an cord type
From what I read Philco went to using brown rubber power cords in 1936, so cloth was used in the 1935 and earlier models...Arran — 11:25 PM
Correct model 84 Ac plug an cord type
Hi Bruce, I have not worked on an 84, but in general, power cords for almost any radio prior to 1938 was cloth covered...MrFixr55 — 08:34 PM
Restoring Philco 38-14
OK, well, so after staring at the sch again, I realized the problem had to be the #12/12A padder. I put a scope on the o...morzh — 08:15 PM
Correct model 84 Ac plug an cord type
Hello Bruce, I mostly use brown far as my cloth powercords go ! Here is the plug that I have used bakelite Acorn style...radiorich — 08:05 PM
Correct model 84 Ac plug an cord type
Looking for as correct as can find the right Ac plug an the correct colored cloth line. Ive seen many old photos but mos...Bruce — 04:13 PM
Restoring Philco 38-14
Rod Two Y-caps make sense if you use them from L/N to the chassis; this is only makes sense in the transformer radios...morzh — 10:11 AM
Restoring Philco 38-14
Mike, I'm curious about a specific use of he Y cap. Lately I've seen a single cap across the power transformer primary. ...RodB — 09:01 AM
Restoring Philco 38-14
hello morzh , That sounds like a plan ! Sincerely Richardradiorich — 07:45 AM
Restoring Philco 38-14
Richard, It helped some, but I still had the whining when engaging the rear power strip (I did not realize it was fro...morzh — 07:07 AM
Restoring Philco 38-14
Hello morzh, Yes , that dreaded hum in my room where i do alighment I have my cable modem and router plus desktop plus ...radiorich — 11:25 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios