Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco Tropic 48-890
#1

   

Hello all

I have unearthed this model from among my father's effects. I don't know much about these radios. It turns on and the tubes glow and it hums, but in terms of frequency, is there anything being broadcast these days on the various bands?

My intention is to sell (we are downsizing). However, I don't know how to "represent" the item in terms of "it works" (other than the glowing and humming thing)

I'm guessing someone in the forum knows a thing or two about this model...

Thank you.


Attached Files Image(s)
       
#2

Hello and welcome!

Your 48-890 is a 1948 model, and as part of Philco's "Tropic" line of radios, was made for export to Europe, Africa, Central/South America and Asia.

The humming indicates failing electrolytic capacitors. You should not attempt to operate the radio any more in that condition.

The AM band (.55 - 1.70 on the dial) is still very active, but there is not as much on the various short wave bands as there was 30 or more years ago.

Please check your private message (PM) inbox - I am sending you a PM about this radio.

--
Ron Ramirez
Ferdinand IN
#3

Welcome to the Phorum!
Icon_wave
#4

thanks




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM
Philco 16B Parts
Hi Dan, Mike is correct, there's a lot of painted stuff on the chassis but it looks pretty good. The sm is all there,sp...Radioroslyn — 03:50 PM

[-]
Who's Online
There are currently 3827 online users. [Complete List]
» 1 Member(s) | 3826 Guest(s)
Avatar

>