1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
Philco K-1633 turntable,speakers in console restoration
Sstiel1
New Member
*
Posts: 1
Threads: 1
Joined: Apr 2019
City: Baton rouge State, Province, Country: La
#1

04-17-2019, 12:35 PM
Hello, I recently acquired a K-1633 model console with working turntable and I’m trying to figure out my best options to restore it. The speakers work when using the ab cables but I cannot get the turntable to work with the speakers. Does anyone have insight on this model? History, year, etc? That may help me with my next steps. I am having trouble finding information on this specific Model online. Thanks!
Find
KCMike
Phorum Expert
*****
Posts: 1,475
Threads: 69
Joined: Nov 2012
City: Kansas city, MO.
#2

04-17-2019, 02:42 PM
Hello and welcome. You might have a look here and see if this looks like what you have.
About the tenth post down is mentioned an K-1633x Philco console.
https://antiqueradios.com/forums/viewtop...1&t=180065
Find
Radioroslyn
Phorum Expert
*****
Posts: 7,273
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#3

04-17-2019, 02:57 PM
Hi and welcome,
Did find a little bit abt your set. It's from 1962. A K-1632 is listed in one service manual in another it list several other model including the '1632. Have a look here  http://www.rsp-italy.it/Electronics/Radi...n/1962.pdf  Go to page 91.
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
Find
« Next Oldest | Next Newest »




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Correct model 84 Ac plug an cord type
From what I read Philco went to using brown rubber power cords in 1936, so cloth was used in the 1935 and earlier models...Arran — 11:25 PM
Correct model 84 Ac plug an cord type
Hi Bruce, I have not worked on an 84, but in general, power cords for almost any radio prior to 1938 was cloth covered...MrFixr55 — 08:34 PM
Restoring Philco 38-14
OK, well, so after staring at the sch again, I realized the problem had to be the #12/12A padder. I put a scope on the o...morzh — 08:15 PM
Correct model 84 Ac plug an cord type
Hello Bruce, I mostly use brown far as my cloth powercords go ! Here is the plug that I have used bakelite Acorn style...radiorich — 08:05 PM
Correct model 84 Ac plug an cord type
Looking for as correct as can find the right Ac plug an the correct colored cloth line. Ive seen many old photos but mos...Bruce — 04:13 PM
Restoring Philco 38-14
Rod Two Y-caps make sense if you use them from L/N to the chassis; this is only makes sense in the transformer radios...morzh — 10:11 AM
Restoring Philco 38-14
Mike, I'm curious about a specific use of he Y cap. Lately I've seen a single cap across the power transformer primary. ...RodB — 09:01 AM
Restoring Philco 38-14
hello morzh , That sounds like a plan ! Sincerely Richardradiorich — 07:45 AM
Restoring Philco 38-14
Richard, It helped some, but I still had the whining when engaging the rear power strip (I did not realize it was fro...morzh — 07:07 AM
Restoring Philco 38-14
Hello morzh, Yes , that dreaded hum in my room where i do alighment I have my cable modem and router plus desktop plus ...radiorich — 11:25 PM

[-]
Who's Online
There are currently 3464 online users. [Complete List]
» 1 Member(s) | 3463 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration