Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

46-1226 Mystery Cap
#1

I'm working on a 46-1226 Am/Lw/Sw/Phono console. Has anyone else done this beastie? There is a rather large cap that I can not determine its value for replacement. I've consulted the Schematic in the Rider's on Nostalgia Air without much luck.

It's a very large yellow tubular cap with wax coating that's located about dead-center in the middle of the bottom of the chassis. The ends are attached to a large terminal strip and one end goes to one of the electrolytic caps and the other to one of terminals on the volume control pot.

I accidentally scratched off the value while trying to cut through the filthy wax. I thought it said something like 25 - but don't recall and there's nothing on the schematic that makes sense.

Can anyone help? I could take a photo of the cap in location if it would help.

Thanks,
James
#2

What C number is it on the riders underside picture?
Terry

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#3

Do you have the schematic for this radio? The service information will tell you what capacitor it is. Philco service literature for their 1946 models are very detailed.

If you don't have it, you need to get hold of Chuck and buy it from him - you won't be disappointed.

http://www.philcorepairbench.com/schematics.htm

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
An attempt to remove the Field Coil from a G speaker
Mike, give this site a look for your spider. Can't hurt. Take care and BE HEALTHY! -GaryGarySP — 12:41 PM
An attempt to remove the Field Coil from a G speaker
Rod, Bubble packaging? The one I know (if you mean the large bubble type) is really thin. I have some at home. Is there...morzh — 12:23 PM
An attempt to remove the Field Coil from a G speaker
Q8. What's the meaning of life? I have read that someone made a spider out of the clear plastic from bubble packagin...RodB — 11:07 AM
An attempt to remove the Field Coil from a G speaker
So, Q1. Does anyone know where to get the spider. Q2. If there is no such place, what material is best? I doubt tin is...morzh — 09:43 PM
An attempt to remove the Field Coil from a G speaker
Arran The oxidation seems to go deep, a few layers. The break starts right there, but then it will occur on every la...morzh — 07:35 PM
An attempt to remove the Field Coil from a G speaker
Mike, This is just a thought, the are on the coil where the verdigris (green oxidation is) I wonder if that is where ...Arran — 06:32 PM
An attempt to remove the Field Coil from a G speaker
Mike; I've made a one or two spiders by using some card stock, and a razor blade, it took more then one try but they ...Arran — 05:48 PM
Philco 91 Restore Code ??
I wondered about that. Wish there was some place local to get this stuff.dconant — 04:20 PM
Philco 89 indicator light.
Bending the lamp bracket (moving the lamp, that is) can possibly change the shape of the pointer a bit, but not its loca...morzh — 04:01 PM
Philco 91 Restore Code ??
Because the usable power rating of it then is (3,200/20,000)*25W= 4W. Maybe a tad more due to the mass, but not much. Yo...morzh — 03:59 PM

[-]
Who's Online
There are currently 4761 online users. [Complete List]
» 2 Member(s) | 4759 Guest(s)
AvatarAvatar

>