Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 16L pilot lamps
#1

My 16L was butchered when I got it. There appears to have been 3 pilot lamps, all #46s. One is to light up the shadow meter, one goes on the back of the movable portion on the band indicator, but I cannot find reference to, nor pics of, where the 3rd one attaches. Does anyone have an idea?

Thanks,

Pat
#2

I'm seeing 5 all together, 1 for each band and one for the sm.
This presumes that it's a 4 band set. The 5 band set only has 2 lamps.
You didn't state how many bands your set has.


Attached Files Image(s)
   

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#3

Sorry, Terry. It's a 5 band. So if the 5 band only has 2 lamps, someone at sometime, for some reason, wired a 3rd lamp in the circuit. Makes sense now.

Thanks,

Pat
#4

The only thing I can think of is perhaps it may fit into the cabinet to backlight some part. If the wire matches the rest of the set then maybe if it doesn't then I would remove it.
I think Ed H has a 16L.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#5

No, the wire was different. It was actually soldered directly to the bulb, rather than using a socket. Since it was a bayonet, and the others are screw type, they probably didn't have a bayonet replacement for a burned out #46 for the dial. The SM bulb was still good. I'll go with that reasoning.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
General Speaker Repair
Hello Guys, Yes, I agree with you Arran I like using good old Elemer's Rubber Cement and I also use Weldwood Contact ce...radiorich — 10:30 AM
General Speaker Repair
Hi Arran, I know what you mean about the silicone. I have a speaker that someone tried to repair with the stuff. They ma...dconant — 09:20 AM
General Speaker Repair
I have used the solvent based general purpose contact cement for years, with few issues, the Bonafede speaker cement is ...Arran — 10:58 PM
37-690 Alignment
I got the double peak alignment part to work by: 1- Discovered that "Fidelity control in expanded position" m...Radiodial — 09:01 PM
General Speaker Repair
There are as many adhesives to use as there are people who repair their own cones. I use Trident Neoprene Cement and hav...RossH — 08:08 PM
37-690 Alignment
The coils have probably degraded, holding corrosion and moisture and your won't get that double high fidelity peak. Make...radio1 — 07:40 PM
Philco Predicta Siesta picture over time getting dimmer
The Siesta has a full on power supply w/a transformer. And if I recall the crt has a 2.5v heater not 6.3v.Radioroslyn — 04:48 AM
Philco 1935 66B
The model 60 vs 66 may look the same from the top and fitment the same but underneath it's a different animal. Back wh...Radioroslyn — 04:27 AM
Philco 1935 66B
From what I have heard looks are somewhat deceiving, whilst the model 60MB (M stands for modern as opposed to the 60B wi...Arran — 01:48 AM
Philco 1935 66B
There is a lot of good info on 66, and also lots of it on 60, which is very close. Actually, some time this week I will...morzh — 10:25 PM

[-]
Who's Online
There are currently 601 online users. [Complete List]
» 1 Member(s) | 600 Guest(s)
Avatar

>