Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

which one???
#1

i realize that this is as controversial of a question as like asking which is the best ice cream flavor but here goes. of all the philco cathedrals of the 30's which one sounds the best? and has decent performance?
#2

It's chocolate !   Icon_lol
#3

i would have thought that selectivity would be better with french vanilla
#4

" . . . selectivity would be better, . . . "   Icon_lol
#5

On a more serious note, is there a specific reason why you are ruling out the tombstones? Icon_question
Ron Ramirez said of the 16B recently : "It isn't perfect, but it is still a great price for the best cathedral radio Philco ever made."
#6

+1 Ron
But if you don't mind having a tombstone the early '36 116B is the one to get. The 10 1/2" H spkr can handle the 10w output stage a little better that the 8" K spkr. It looks like the design is a work in progress on the 16B code 121 ('33 cathedral) as there a lot of updates in the service notes. The later runs of the 16B and the 116B have a much more effective tone control circuit than the code 121 (the '33 cathedral) pretty much just cuts the high frequency response from the audio.
On the rf/if side of things the later runs have a rf amp where the code 121 has the qave circuit. The alignment on the later runs is more straight forward and helps to make the set more accurate.

GL on your search!

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#7

My answer was from the point of view of cathedral radios. Terry is correct that the early 116B is the mack daddy of all prewar Philco table model radios (excluding some immediate prewar Tropic models which are extremely rare). But the 116B is a tombstone, not a cathedral.

--
Ron Ramirez
Ferdinand IN
#8

BUTTER PECAN, or don't put it in front of me!!! Take care, Gary

"Don't pity the dead, pity the living, above all, those living without love."
Professor Albus Dumbledore
Gary - Westland Michigan
#9

thanks for your replies. i just think cathedrals are better looking than tombstones, but what matter's most to me is how they perform. most seller's dont or wont ship here in any case so it might be an exercise in futility. one last question the 84b up and running but not aligned. i get a signal generator hopefully on monday. its another national vp-8177a. im not exactly sure whats the best way to connect to the set. is the .0001 mica still the best way?
#10

That 84 is my favorite of the cathedrals.  Wish my 89 were an 84!
  Sorry,. ..I don't know on that alignment question.  Maybe Terry can help there.




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 42-390, code 121 speaker
Using a 5W  1.5k  ceramic resistor in place of the field coil and using a 4 ohm PM speaker, I was able to bring the radi...Stevelog — 02:57 PM
Philco 60 Squealing
I have taken out the 2nd IF and found a problem or not. I believe the coils are litz wire. There is a very small strand ...dconant — 02:13 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio.  This is a shame because this should be a good performer.  2A5...MrFixr55 — 06:48 AM
American Bosch Model 802 auto radio
I think it would come under either American Bosch or United American Bosch. American Bosch made sets for the American We...Arran — 05:53 AM
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM

[-]
Who's Online
There are currently 6358 online users. [Complete List]
» 1 Member(s) | 6357 Guest(s)
Avatar

>