Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

53-960 found
#1

I bought this Saturday (8/17/2019) at the SCARS swap meet.  I need the tone-off knob and the back.  Do you think they considered having FM?  It has a large blank space beside the tuning gang, perhaps for a separate FM tuning gang they decided not to use...

 [Image: https://i269.photobucket.com/albums/jj77...age004.jpg]

Web site: http://www.masekconsulting.net
Radio Photos: http://www.photobucket.com - album id FStephenMasek
#2

I sort of like that thing..it’s 1953, like me!
#3

I have this model, it sounds great. For FM I have a Pilot tuner that I connect to the phono input, works well.

Steve Chambers
#4

I've always wondered what prompted Philco to offer this radio, which is in essence a Philco Tropic model made for domestic (USA) sale. It was certainly Philco's last hurrah as far as a really good AM/SW table model radio is concerned.

As for FM or the lack of same - only some long dead Philco engineers know for certain. The 53-960 does have a conventional tuning condenser above the chassis for standard tuning of AM and a few SW bands, and permeability tuning under the chassis for the "spread bands" (49M, 31M, etc.).

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM

[-]
Who's Online
There are currently 3706 online users. [Complete List]
» 1 Member(s) | 3705 Guest(s)
Avatar

>