[whitmire]

I'm new to the phorum and have a question concerning a Philco Model 70 (serial #< 22,000) I am restoring. The BC resistor has two sections which have buned out. The transformer tests OK, but I am replacing the electrolytics. According to the Philco Repair Bench site, the values of the part I have (# 5125) are 240, 70, 2300 and 1060 ohms respectively. Although, the schematic I have indicates the first value at 180 ohms. In any event, I have been unable to locate another BC resistor 5125 and need to come up with a suitable substitute for the 240 (180) and 1060 ohm sections of the resistor. Any advice concerning replacement parts would be most appreciated. Regards, Thom.

[Radioroslyn]

keep your eyes open for 1K and 200ohm @ 10w
Should be easy to find.
Terry

[whitmire]

Thanks for the quick reply, Terry. I noticed someone on another forum had used a 50 watt resistor. Seemed excessive. Regards, Thom