Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Ron's RCA T7-5 Electronic Rescue

What does rating "A" signify stamped on chassis back side?

Paul

Tubetalk1

105-125 volts, 50-60 cycles.

There was also a rating "B" = 105-125 volts, 25-60 cycles; and a rating "C" = 100-130/140-160/195-250 volts, 40-60 cycles.

--
Ron Ramirez
Ferdinand IN

Hey, I know this thread is over a year old but it has and will be a great help for me as I am restoring this radio as well.

Thanks Ron

Jim
Spring Lake MI

Hey Jim, you live just down the road a piece. I'd like to see what you have sometime!

I just read through this whole thread. Ron's radio is virtually identical to my T8-18, except for not having the tuning eye tube. It was very interesting to see how we approached certain problems differently. I used a small pair of very thin needle nosed pliers slipped behind the pointer, and liberal PB Blaster applied to the shaft using a little paint brush, and managed to free it up to remove it. Mine had all replacement electrolytics, and I am not as much of a purist as Ron, so, with plenty of room beneath the chassis, I simply replaced the caps on the underside with new electrolytics with higher voltage ratings, 2 10 MFD and 1 20MFD. We both encountered the exact same candohm gone bad, and the same remaining good. My bad one had both sections gone, so I merely soldered new resistors of suitable wattage across the gaps in the candohm. Both our speakers were bad, and neither had a center spider. I don't think they originally had one. He sent his away, and I rebuilt mine myself. It was really interesting to read through the thread. Brought back a lot of memories of repairing mine. It now works great. I have been listening to the playoffs and now to the world series on it, sometimes on stations as far away as Chicago and Cincinnati. Great radios ! Tonight I am listening on WRVA 1140 in Richmond, VA. It's coming in like it was next door, not more than 300 miles.




Users browsing this thread:
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently 2692 online users. [Complete List]
» 3 Member(s) | 2689 Guest(s)
AvatarAvatarAvatar

>