Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

1931 Westinghouse WR-10 Tombstone Radio
#1

Hello Everone, recently I was given a 1931 Westinghouse Model WR-10 Tombstone Radio which when I first got it that cabinet was shot but the guts were still good on it (the radio was found in an old abandoned farmhouse that the roof had collapsed on it 20 years ago and the radio had sat in that house all that time which is why the cabinet was basically rotted to the point that it was falling apart).

Anyways I had bought a new cabinet for it on ebay for $30 plus shipping and cleaned up the chassis and replaced some a couple of bad paper caps in the chassis and the original cloth cord as the cord had a break in it somewhere that caused it to not power on when it was plugged in with a brand new cloth cord (basically a modern rubber cord with a cloth sheathing around it), and plugged it in a turned it on, and sure enough the radio worked like brand new still even with its original dry electrolytic filter capacitors intact, and the radio is super sensitive, as I was able to some major DX'ing on it at night where I was picking up stations from all over the country including an oldies station from Ontario, Canada, and all I was using was a 30' length of zip-cord for the antenna that was stretched out across my basement and clear upto the kitchen upstairs.

I have some pictures of the unit in question posted below.

Sorry about the poor lighting in the pictures, my basement isn't very well lit.


Attached Files Image(s)
           




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
New Philco Repair Bench
I am sure this is the archive, and not the Chuck's site.morzh — 09:50 PM
Made mistake & did not label connection
It's not like we are good friends with that wire and can tell it from other ptetty identical looking wires. Why'n't you...morzh — 09:49 PM
Made mistake & did not label connection
I'm not sure why that wire wasn't covered in the video. I'm pretty sure the 6A8 won't work until that pin is grounded. Y...RodB — 09:47 PM
Made mistake & did not label connection
You'll have to forgive me, I am not sure what you mean.  Can you explain what you are really saying.  If anyone does not...georgetownjohn — 08:05 PM
Made mistake & did not label connection
Those are details better left to the ones who know. Maybe you disconnected the wrong end of the wire.RodB — 06:22 PM
Made mistake & did not label connection
Maybe this is starting to make some sense in my hard head.  Is this why the wire in question was not in the great Ron Ra...georgetownjohn — 04:34 PM
Made mistake & did not label connection
I was correct with the 6A8 pin connection's, 7 and 8 are connected to ground as well as the tube shield (the broken line...RodB — 02:41 PM
Made mistake & did not label connection
What does the dotted line representing that surrounds the tube in the schematic?georgetownjohn — 02:17 PM
Made mistake & did not label connection
Hello John, I have been there either label got lost or was not labeled ! Sincerely Richardradiorich — 02:15 PM
Made mistake & did not label connection
Sorry, it is a Philco 37-640.  Does that help?--Johngeorgetownjohn — 02:14 PM

[-]
Who's Online
There are currently 3239 online users. [Complete List]
» 1 Member(s) | 3238 Guest(s)
Avatar

>