Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

How popular was the Philco 87?
#1

As I test and revive the Philco 87 lowboy in my bedroom, a question has come to mind: Just how popular was this model? I know in my area if a 1929/30 era Philco console appears for sale that there is a 90% chance that it's an 87. In fact, I am amazed at how often this model still pops up for sale, though not as often as in the past with the occasional 95 in the mix. I think I have seen only one model 65 pop up for sale all these years, but it was about three hours away from my place! Icon_eek  I have only run across parts chassis in my area for the model 65 and 76 in my neck of the woods. So, either the 87 was super popular or the salesmen in the Cleveland, Akron, and Canton, Ohio regions were really good! Icon_smile Heck, I have three myself! Two lowboys and one highboy!

P.S. My good lowboy still works and acts like I had just used it the yesterday, in spite of sitting for over a year. Not bad for a semi-restored radio! Runs a lot cooler on that resistor box I had made. That former Zenith employee did a good job on that! Icon_biggrin

No matter where you go, there you are.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
New Philco Repair Bench
I am sure this is the archive, and not the Chuck's site.morzh — 09:50 PM
Made mistake & did not label connection
It's not like we are good friends with that wire and can tell it from other ptetty identical looking wires. Why'n't you...morzh — 09:49 PM
Made mistake & did not label connection
I'm not sure why that wire wasn't covered in the video. I'm pretty sure the 6A8 won't work until that pin is grounded. Y...RodB — 09:47 PM
Made mistake & did not label connection
You'll have to forgive me, I am not sure what you mean.  Can you explain what you are really saying.  If anyone does not...georgetownjohn — 08:05 PM
Made mistake & did not label connection
Those are details better left to the ones who know. Maybe you disconnected the wrong end of the wire.RodB — 06:22 PM
Made mistake & did not label connection
Maybe this is starting to make some sense in my hard head.  Is this why the wire in question was not in the great Ron Ra...georgetownjohn — 04:34 PM
Made mistake & did not label connection
I was correct with the 6A8 pin connection's, 7 and 8 are connected to ground as well as the tube shield (the broken line...RodB — 02:41 PM
Made mistake & did not label connection
What does the dotted line representing that surrounds the tube in the schematic?georgetownjohn — 02:17 PM
Made mistake & did not label connection
Hello John, I have been there either label got lost or was not labeled ! Sincerely Richardradiorich — 02:15 PM
Made mistake & did not label connection
Sorry, it is a Philco 37-640.  Does that help?--Johngeorgetownjohn — 02:14 PM

[-]
Who's Online
There are currently no members online.

>