Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 38-10 schematic question
#1
Photo 

Hi all. First, let me first admit I am a beginner. This is my first restoration — a model 38-10. While replacing caps and resistors, I've discovered one resistor in the chassis not listed on the schematic, and one listed but not found in my chassis or in any photos of this model I can find. The resistor missing from the schematic is shown in the photo with the red arrow pointing to it, between cap #33 and cap#38. The resistor that shows up on the schematic but not in the chassis is #32—330k. The two 1.0 meg resistors are there, but not the 330k. 

Can anyone shed light on this for me? I'm attaching parts list and schematic. Thanks for any help you can offer.                     
#2

Ok so if we follow the wire on the schematic on pin 4 of the 6F6 (screen grid) down and over it goes to #32 330k resistor the other end of the resistor goes to eventually to the plate of the triode section of the 6Q7. Long story short it's #32. The two 1megs are 18 & 27.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#3

Thanks, Terry. I guess it's just a mis-labeled location on the parts location diagram.




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
HiFi (Chifi) tube amp build - but my own design.
Tim Well...a chassis is metal. Magnetic or not, it does not matter. A transformer has some hum to it. It is natural....morzh — 08:40 PM
Shadow Meter Bulb
Ross I am not sure what current limiting effect the incandescent provides. They are two different parts of the sch...morzh — 08:31 PM
12' Philco
Bob Thanks for that photo. I have been looking for it, and I cannot find anythinmg on the web. I forgot it was here...morzh — 08:29 PM
Shadow Meter Bulb
I think after all has been said, I will use the same bulb that is specified for the dial pilot light which is a #55. I ...georgetownjohn — 07:31 PM
12' Philco
There was also this Philco! klondike98 — 07:25 PM
HiFi (Chifi) tube amp build - but my own design.
I expected a challenge and this is just part of it. But, it's also supposed to be fun, entertaining, informative and enj...TV MAN — 07:12 PM
Shadow Meter Bulb
Butting in here with a question. Since the shadow meter is connected directly to the 1st and 2nd I.F.'s wouldn't the met...RossH — 06:43 PM
HiFi (Chifi) tube amp build - but my own design.
Mike, Tim; you are about to enter the twilight zone. Doo doo doo doo, doo doo doo doo This is something alright. I'm go...RodB — 06:26 PM
HiFi (Chifi) tube amp build - but my own design.
:lol: We need to start a singing radio group! I play the guitar, so maybe get a few vocals? Anyways, Mike, I did try mou...TV MAN — 05:56 PM
HiFi (Chifi) tube amp build - but my own design.
And so does a barber shop quartet. mmmmmmRodB — 03:54 PM

[-]
Who's Online
There are currently 6623 online users. [Complete List]
» 3 Member(s) | 6620 Guest(s)
AvatarAvatarAvatar

>