Philco 38-35 Antenna Length?

Register

Guest Join Us

Hello Guest,

Please feel free to join us!
There are many more parts of the Phorum that only members can see.

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Philco 38-35 Antenna Length?

NV3G
Member

Posts: 74
Threads: 42
Joined: May 2008
City: Shinnston, West Virginia State, Province, Country: USA

#1

03-23-2020, 11:45 AM

I am using number 18 wire. Would 25 feet be enough for reception?
Thank you,

Oscar

(This post was last modified: 03-25-2020, 10:27 AM by NV3G.)

Find

RodB
Phorum Expert

Posts: 990
Threads: 40
Joined: Feb 2015
City: Roseville, MN

#2

03-23-2020, 12:58 PM

Hi, I looked at the schematic for a 37-93, which has a very similar circuit, and it shows a consumption of 50 watts, less than half an amp of current.

Rod

Find

radiodale
Member

Posts: 93
Threads: 20
Joined: Aug 2014
City: Greenville, TX

#3

04-12-2020, 10:34 PM

Oscar,
Should be enough. How far are you from the AM stations?

Dale

http://www.dalesantiqueradio.com/

« Next Oldest | Next Newest »

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online
There are currently no members online.