Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

A little advice
#1

I am considering the purchase of a philco 38-2670 tombstone and was hoping someone that is lucky enough to own one of these beauties could comment on the sound the radio produces. The person selling says it is really exceptional in volume and audio quality.
I can usually find a you tube video of any radio I’m looking at to at least get an idea but not this one.
I have not been able to even find the speaker size so it must be a fairly rare radio.
Any comments on what I should be paying would be appreciated, it is fully restored. Thanks in advance
#2

Looks like the spkr is an 8" the console uses the 10 1/2". The output stage is the super class A style (mostly found in console models) using 6F6's rather than than the older standard base 42's. It's a little different it has a phase inverter stage instead of a 42 driving the pair of 42's thru a transformer. Performance wise it should be able to blow the spkr out of the cabinet. Rf/IF wise nothing too exciting rf amp, pentagrid mixer, single IF amp, and det/avc circuit.

GL

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#3

So if you were using an external source for music or news or whatever it should preform very well.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM

[-]
Who's Online
There are currently 4729 online users. [Complete List]
» 1 Member(s) | 4728 Guest(s)
Avatar

>