Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 18
#1

Hello, again !
I just picked up a nice Model 18 with the original back still on it...It is different than the 18x shown on Philcoradio.com, though. The main difference is that it has 2 of the lyre inlays.. One at the top of each of the fluted trim pieces, instead of the single centered one...What other differences are there between the 18 and 18x? I don't know if it works or not,but for $20, I don't really much care.It's pretty nice cosmetically.I haven't had a free minute to throw it on the variac or get photos as of yet, but I will try in this coming week.
Andy
#2

Do you mean like this one?

http://www.philcoradio.com/gallery/1933d.htm#e

This, too, is an 18X. Very nice set, and you managed to acquire it at a bargain-basement price. Looking forward to the photos! Icon_smile

--
Ron Ramirez
Ferdinand IN
#3

No... it's like the ones on the 1935 (fall 1934) page... They use the same photo for the 18x, 49x, 118x, and 144x. but like the 1933 model you showed me, it has the lyres atop each fluted side trim. The inside label tags it as a Model 18... not 18x... The place I got this one also has another pretty rough Philco R/P Console with a missing label.... It has almost the same face as my 41-250, but the dial scale has more printing on it, and it has the more rectangular push buttons. It has a low speaker, and mid pull out phonograph. On either side of the phonograph, there are large rectangular openings that look like record storage pockets missing the doors.. It was very crowded in, and I couldn't get a very good look at it. I could snap it up real cheap... but I don't know what I would do with it. I don't really want any more basket cases....
Andy
#4

andyjon100 Wrote:They use the same photo for the 18x, 49x, 118x, and 144x.
It's my website, and I put the photos there since according to Philco Furniture History, those four models used the same cabinet. I really don't like using those poor quality illustrations, but I depend on other folks such as you to furnish better quality photographs. So...I'm hoping you would be willing to share photos for the Gallery. Icon_smile

Oh yes, it's an 18X. It will not say 18X inside. It will only say "CHASSIS TYPE 18" on the back of the chassis, and "PHILCO MODEL 18" on the tube layout sticker. But if it is like this one:

http://www.philcoradio.com/gallery/1935b.htm#b

but with two lyres instead of one, it's still an 18X.

Regardless if it's a 1933 or 1935 model, it was still a bargain.

--
Ron Ramirez
Ferdinand IN
#5

Ron... I would be happy for you to use photos of my 18 on your site! I'll get some up here as soon as I am able!
Andy




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM

[-]
Who's Online
There are currently 4739 online users. [Complete List]
» 2 Member(s) | 4737 Guest(s)
AvatarAvatar

>