Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

38-38 Mystery Part
#1

I'm considering picking up two consoles this weekend. My interest is mainly in a 610.  Due to a proviso that 'both must go,' I'm towing a 38-38 along with me. It will be my introduction to the farm radio experience which I am mildly excited about. I asked the seller if the radio had been upgraded for AC use only because he said it last played about ten years ago (haven't they all?) Anyway, he said it had a cord and plug and I noticed a contraption in the bottom of the cabinet which I did not recognize (see attached.) Can anyone please educate me on the purpose of this mystery part? Thanks in advance.


Attached Files Image(s)
   
#2

Looks like a power pack to allow operation on mains power. http://www.nostalgiaair.org/Resources/248/M0013248.htm     Looks like a fun project, or it could be the flux capacitor out of a time machine! Some more info https://philcoradio.com/phorum/showthread.php?tid=21485
#3

Thanks for the info David. That sounds promising about the former. Hedging my bets, does Riders contain a schematic for the latter? I may need it to go back and pick up the former.
#4

Might be one of these: http://www.nostalgiaair.org/pagesbymodel...017907.pdf

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#5

Great. Thanks Terry! I will definitely pore over that literature. I'm very green on radio repair in general so this will be a big help in trying to understand how these adaptors work.
#6

Some more info on a battery eliminator   https://philcoradio.com/phorum/showthread.php?tid=21451
#7

Thanks David and Terry for pointing me in the right direction on this. You guys were right on, as expected. I saw the Sears silvertone and Electro (pictured below) models of the battery eliminator and they look almost identical to the image I have. Thanks again, I really appreciate your help.


Attached Files Image(s)
       




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Correct model 84 Ac plug an cord type
From what I read Philco went to using brown rubber power cords in 1936, so cloth was used in the 1935 and earlier models...Arran — 11:25 PM
Correct model 84 Ac plug an cord type
Hi Bruce, I have not worked on an 84, but in general, power cords for almost any radio prior to 1938 was cloth covered...MrFixr55 — 08:34 PM
Restoring Philco 38-14
OK, well, so after staring at the sch again, I realized the problem had to be the #12/12A padder. I put a scope on the o...morzh — 08:15 PM
Correct model 84 Ac plug an cord type
Hello Bruce, I mostly use brown far as my cloth powercords go ! Here is the plug that I have used bakelite Acorn style...radiorich — 08:05 PM
Correct model 84 Ac plug an cord type
Looking for as correct as can find the right Ac plug an the correct colored cloth line. Ive seen many old photos but mos...Bruce — 04:13 PM
Restoring Philco 38-14
Rod Two Y-caps make sense if you use them from L/N to the chassis; this is only makes sense in the transformer radios...morzh — 10:11 AM
Restoring Philco 38-14
Mike, I'm curious about a specific use of he Y cap. Lately I've seen a single cap across the power transformer primary. ...RodB — 09:01 AM
Restoring Philco 38-14
hello morzh , That sounds like a plan ! Sincerely Richardradiorich — 07:45 AM
Restoring Philco 38-14
Richard, It helped some, but I still had the whining when engaging the rear power strip (I did not realize it was fro...morzh — 07:07 AM
Restoring Philco 38-14
Hello morzh, Yes , that dreaded hum in my room where i do alighment I have my cable modem and router plus desktop plus ...radiorich — 11:25 PM

[-]
Who's Online
There are currently 4658 online users. [Complete List]
» 1 Member(s) | 4657 Guest(s)
Avatar

>