Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

38-38 Mystery Part
#1

I'm considering picking up two consoles this weekend. My interest is mainly in a 610.  Due to a proviso that 'both must go,' I'm towing a 38-38 along with me. It will be my introduction to the farm radio experience which I am mildly excited about. I asked the seller if the radio had been upgraded for AC use only because he said it last played about ten years ago (haven't they all?) Anyway, he said it had a cord and plug and I noticed a contraption in the bottom of the cabinet which I did not recognize (see attached.) Can anyone please educate me on the purpose of this mystery part? Thanks in advance.


Attached Files Image(s)
   
#2

Looks like a power pack to allow operation on mains power. http://www.nostalgiaair.org/Resources/248/M0013248.htm     Looks like a fun project, or it could be the flux capacitor out of a time machine! Some more info https://philcoradio.com/phorum/showthread.php?tid=21485
#3

Thanks for the info David. That sounds promising about the former. Hedging my bets, does Riders contain a schematic for the latter? I may need it to go back and pick up the former.
#4

Might be one of these: http://www.nostalgiaair.org/pagesbymodel...017907.pdf

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#5

Great. Thanks Terry! I will definitely pore over that literature. I'm very green on radio repair in general so this will be a big help in trying to understand how these adaptors work.
#6

Some more info on a battery eliminator   https://philcoradio.com/phorum/showthread.php?tid=21451
#7

Thanks David and Terry for pointing me in the right direction on this. You guys were right on, as expected. I saw the Sears silvertone and Electro (pictured below) models of the battery eliminator and they look almost identical to the image I have. Thanks again, I really appreciate your help.


Attached Files Image(s)
       




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Need Help to ID this radio 11 tube Philco
Yes the 16B as morzh pointed out. Specifically its the January 1935 model version of the 16B. There are a couple earli...klondike98 — 11:51 PM
48-482 rear panel help
Welcome to the Phorum, keithchip! How far you take a radio on cabinet restoration is a matter of personal preference. ...GarySP — 11:28 PM
48-482 rear panel help
I've recently finished the internal restoration of a locally purchased Philco 48-482. The cabinet is in ok shape except ...keithchip — 10:28 PM
Need Help to ID this radio 11 tube Philco
Welcome to the Phorum, Ken! Lots of help here for all of your restoration questions. Take care and BE HEALTHY! - Gar...GarySP — 07:59 PM
Need Help to ID this radio 11 tube Philco
Thank you. I went to your online library and found 2 schematics. I will download and compare to components!Ken D. — 06:31 PM
Need Help to ID this radio 11 tube Philco
It is a 16B tombstone.morzh — 06:13 PM
Zenith H725
David - sorry, I reread your post and finally saw THD - now the % figures make sense. Thanks for explaining. The PSU...EdHolland — 06:06 PM
Need Help to ID this radio 11 tube Philco
Hi Everyone, New member but have been reading this for awhile for tips! Vaccum tubes were before my time so bear with ...Ken D. — 06:03 PM
My Philco 37-116 Restore
Thank you MrFixR55, I appreciate your comments very much. I do not detect much hum if any so I will be staying with the ...dconant — 05:15 PM
My Philco 37-116 Restore
Hi DConant Yes, you can replace chokes with resistors.  You do stand the risk of increased hum.  the solution is to inc...MrFixr55 — 04:23 PM

[-]
Who's Online
There are currently no members online.

>