Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Zenith 8S-531
#1

Looking for a detailed layout of the underside of this radio.. Parts layout and wiring..

USES CHASSIS Number 8A02

Does anyone have or maybe worked on this and has some detailed drawings they made??

Thanks

Skip
#2

Anyone have a clue to what this is? and were the white wire goes??


[Image: https://live.staticflickr.com/65535/5026...b57f_c.jpg]

Skip
#3

Wherever the white wire is supposed to go it's a fairly late addition to the radio, probably because the original was a crumbling rubber wire.

Maybe that's the antenna coil?  It's hard to tell from that small view, can you post a picture of the entire underside of the chassis?

For anyone following the schematic is in volume 12, Zenith p. 12-18

.pdf Zenith 8-S-531.pdf Size: 936.66 KB  Downloads: 164

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"
#4

First you need to figure out which coil it is (ant or osc). Then use an ohm meter to see what relationship the white wire has to the other terminals on the coil. Using the schematic sort out where the wire goes. Piece of cake!! Icon_twisted

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM

[-]
Who's Online
There are currently 4112 online users. [Complete List]
» 3 Member(s) | 4109 Guest(s)
AvatarAvatarAvatar

>